When one bulb burned out, a small section of light goes out.
Loading refers to the phenomena that occurs when a load circuit having low effective impedance is connected to a supply circuit having higher effective impedance.
A voltmeter does not measure current, it measures voltage in units named volts. An ammeter measures current in units named amperes or amps in common shorthand. A voltmeter is connected in parallel to the circuit being measured, whereas an ammeter is connected in series with the circuit being measured.
A simple circuit consists of a source of electro motive force ( EMF or voltage V ) This could be a battery,dynamo or solar cell. The circuit should do something, like light a lamp. For the lamp to glow there must be a flow of electrons called an electric current measure in Amperes (I). For the current to flow the circuit must form a closed loop, like a daisy chain. A switch is a device that breaks this loop and controls the state of the circuit. Closed circuit, switch closed, = lamp on Open circuit, switch not closed = lamp off
A series circuit has all its elements connected in a sequence so the same current flows through each the same while A parallel circuit has many paths for current to travel and more than one resistor, outlet or switch.An example for each would be Christmas lights. If you take out one light bulb on a series circuit all the lights will go out because of an uncomplete circuit. If it were parallel circuit the rest of the lights wouldn't go out because in a parallel circuit there is more than one path for the current to follow. This allows you to take one out without all the others turning off. It would save you alot of trouble on Christmas if one light burned out!A; No difference as far as a source is concerned it is load of different type
Closing a switch in an electrical circuit will complete the circuit. The supply voltage will then be applied to that circuit, and current will flow through that circuit.
An ammeter is always connected in series in the circuit.
A circuit in which loads are connected side by side is known as a parallel circuit.
it is connected in a box
Voltmeters are connected to simple series circuits the same way they are connected to any circuit. They are connected in parallel with the portion of the circuit for which you wish to measure the voltage drop.
RC Circuit
In principle, it is infinite. I have not connected a parallel circuit in ages.
A volt can not be connected to a circuit.
Two or more electrical components connected together is called a circuit. Depending on how components are connected, it is either an open circuit, closed circuit, or a short circuit.
A circuit in which elements are connected in series.For example in RLC series circuit resistor,inductor and capacitor are connected in series.
Ammeter is coneccted in series with circuit but Voltmeter is connected in parallel.
To measure the current in the circuit an ammeter is used and it is connected in series
I have two resistors, a 2-ohm and a 3-ohm.What is their combined effective resistance when they are connected in series ?Answer: R1 + R2 = 5 ohmsWhat is it when they are connected in parallel ?Answer: 1 / [ (1/R1) + (1/R2) ] = 1.2 ohms