ako budoii
An atomic clock should set itself once it receives the calibration signal .
It chooses the access point with the stronger signal
have a tv station and transmit a signal
Yes. A TV set is a radio receiver.Some of the information it receives on the signal is intended to be heardand is sent to the loudspeaker.Other information received from the signal is intended to be seen and isdisplayed on the screen.
Every soldier receives one pair of dog tags in Basic Training. When the soldier gets to his first duty station, he normally receives a second set.
La Televisión = Television signal, program, station. Sometimes TV set, but not correct usage. El Televisor = Television set. La tele - slang
If you mean a set top digital box, then you can connect that to any tv.... otherwise..... It doesnt work that way. The digital signal is a part of the analog signal. Just screw the cable wire on to the back of your tv.
It is just like radio through the air: lots of channels travel together through the mediumm (air) and don't (usually) interfere with each other. Officail (in the US the FCC does this) tables of frequency allocations set the spacing so interferance between channels doesn't occur. Radio signals can travel over copper wire even better than through the air. So a cable station effectively makes a tiny transmitter for each channel the customer receives, then combines all those signals and applies the combination signal to their end of the cable. The combined signal travels over the cable, aided by amplifiers that extend the distance, all the way to the customer's TV set. In the set, the tuner extracts the signal that you want to watch from the cable , it "tunes" in the signal out of all those that were combined, just the way it would tune in a station from an antenna in the air.
Try rescanning the set. Did the antenna get turned to a wrong direction?
Set-top- box signal
Two pairs of Infrared LEDs are used as motion sensor detector. The first one is wired to emit LED and the second is wired to transmit a signal when it receives an infrared input. this infrared is reflected back to the receiving LED and then the signal is produced. This signal can be used to open sliding doors, turn on a light or set off an alarm.
It depends the wireless station software. Most of them can be configured which network to connect to by specifying SSID, IP address or MAC (depending on software).