We are doing a 1992 skylark and we turned the bolt to the right. It was very tough to get off because of the lock tight they put on but it came out, now we are having trouble getting the tool in the slots to remove the drum itself.
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
It's just behind the harmonic balancer.
a 1991 buick skylark has 4" speakers in the dash and 6x9's in back
how do you replace a ignitionswitch tumbler 1991 buick skylark
The thermostat on a 1991 Buick Skylark is located near the engine. To find the thermostat, follow the top radiator hose directly to the thermostat.
where does a clutch relay seleniod go in at on a 1991 buick skylark
to my knowledge it is located behind the harmonic balancer. You should be able to c the wires runing to it just to the right of the harmonic balancer. Now if you could help me with information on how to uninstall the harmonic balancer i would greatly appreciate it Thanks. To remove the harmonic balancer you have to buy or rent a harmonic bancer puller. The bolts required for yours may not be included. If not you will have to go to the hardware store and purchace them. You should use the 3 1/2 inch #8 1/4 inch bolt 3 required also buy 3 washers cost under 4 dollars.
the crank sensor is behind the harmonic balancer
I'd say about 2.5 tons.
If it has a coolant tank, that's the "cap".
You can find the 1991 Buick Skylark radiator drain plug on the bottom of the radiator. The radiator drain plug will be in the center of the radiator bottom.
Behind the harmonic balancer (dampner) that is located behind the crankshaft pulley.