Cutting diamonds began in the Middle Ages, and the first person to perform this task has a name that has been lost to history.
You can read more about diamond cutting, below.
A brief search turned up the link, below, where you can learn more about the American Institute of Diamond Cutting. NB: This reference does not endorse the company.
No one knows exactly when, where or who made the first attempt to cut diamonds. It is assumed that the first diamond cutting styles originated from India. However, it was only limited to chipping or grinding. In ancient times diamonds were valued more for their magical and mythological properties. It was thought that by modifying the natural state of a diamond in any way would alter its magical properties and render it useless. At the most the cleaving techniques of diamond were attempted to get flat faces on diamonds. It is believed that the early diamond cutting styles originated in Europe. The European travelers visiting India for its diamond treasures used to transport diamonds from the Golconda Mine to Europe for cutting.Experimentation with diamond cutting did not yield any significant results till the seventeenth century. The early diamond cutters were unable to polish the rough octahedral diamonds. However, they found out that they could polish or grind diamonds into a point by polishing almost parallel to the diamonds rough faces, at an angle lesser than the diamond rough faces. They also realized that only diamonds cut diamonds. Hence they used a wooden table covered with diamond dust to achieve any kind of polishing. This resulted in the "Rose Cut". It was called the rose cut due to its resemblance to the "Rose Bud". The rose cut came into existence in the early sixteenth century and was widely used till the early nineteenth century.However, whilst you cannot scratch a diamond with a piece of steel, if you hit a diamond with a large bit of it (called a hammer) the diamond can easily be chipped, split or even shattered!
Faceting and polishing are two separate steps in the process of manufacturing a sale-able diamond from a raw stone. However, early diamond fanciers -- beginning as early as 6,000 BC in India -- may have simply polished the existing four facets on a naturally-occurring, pyramid-shaped diamond stone and considered the stone 'finished'. (History, however, brought diamond cutting -- faceting -- into the ever-developing story of diamond manufacturing.) You can buy a 'diamond in the rough' ring from Nieman Marcus today that appears much like the early un-cut diamonds may have appeared centuries ago: link, below.
There is many of ways to use the word "cutting" in a sentence. You can say "I am cutting the meat up to cook.".
National Geographic published a cover photograph, for their story on cutting and polishing diamonds in India, which showed diamonds small enough to fit into the seed well on the side of a strawberry. These diamonds are probably smaller than .01 carats. A 'one cent' diamond weighs one-one-hundredth of a carat -- .01: its mm size will depend on its cut.
The process is called diamond cutting.
Because diamond is the hardest substance.
Glass can always be cut by diamond, so if precision is required over a variety of glass types, diamond will be preferred as the cutting tool.
A diamond saw which is a steel wheel with a soft coper rim into which diamond dust is pressed. The cutting process needs to be cooled with water.
Instruments fitted/studded with higher quality of diamonds in small size can only be used for diamond cutting.
Yes. Diamond encrusted blades and diamond powders are used in the cutting and polishing process.
Henry Grossbard invented the radiant cut diamond in 1977.
Sorry, no, I don't.
it's hardness
Try cutting glass with it
a dimond
Any such visible flaw would be removed in the diamond cutting process, if the diamond is to be sold as a gemstone.