take up 12 inches of the sheet at the edge about 45 degrees, place it at the top of the bed, fold under the remaining sheet. take the sheet you have place on top of the bed, and fold it under the bed. do the same for the other corners.
A miter can be:bishop's hatsurface of miter jointdiagonal join at corner between hems (sewing)
wow a 45 degrre stair case is mighty steep but both miters should be 22.5 degrees
How to miter 4" sch. 10 pipe s.s. on 22.5 degrees.
30
If you are doing a 90 degree corner, the miter angles with each be 45 degrees at the cut. If you are doing a corner that is not square - you are going to need a protractor or another device to measure the angle. Square corner or not, the sum of the miter angles will equal the total angle of the corner.
You need a miter saw. It has a back gauge to butt the wood up to, and then the saw has holders to keep it from wobbling. You can set the angle. It may just have notches for 90 degrees and 45, or it may have a protractor on it.
A 45 degree cut.
In mitering the pieces that form the angles of an octagon, the miter saw should be set at 22-1/2 degrees.
135 degrees is the supplement of 45 degrees. When you minus 45 degrees from 180 degrees you will get 135 degrees which is the supplement angle of 45 degrees.
A miter line is a 45 degree line draw between the top view and right side view by extending out a line on both view and connecting them. From that connection make a 45 degree line. Then you can copy line from the top view and bring them over to the miter line and make a mark. Then copy it down to the right side view vise versa.
A miter line is a 45 degree line draw between the top view and right side view by extending out a line on both view and connecting them. From that connection make a 45 degree line. Then you can copy line from the top view and bring them over to the miter line and make a mark. Then copy it down to the right side view vise versa.