Want this question answered?
In parallel connection all the positive terminals are connected with positive of the source and all the negative terminals are connected to negative of the source. Whereas in series connection one positive terminal is connected to the negative of another, like wise it goes on and finally the positive end is connected to the negative of the source.
If your dash lights aren't coming on, but everything else does, then it's the Potentiometer. Take out the instrument cluster and remove the potentiometer. You can simply clean all of the contact points or replace it with a new part (see Performanceproducts.com for parts).
EMF (E''electromotive Force'') is another term for Volts, hence the E in electronic formulas and EMF is measured with a volt meter. A potentiometer is not a meter at all, it is a variable resistor
elevation & the unit is in feet
Resistors are either fixed value, or variable. A variable resistor has three terminals; one at either end and one attached to a moving 'wiper', and can be connected either as a potentiometer or as a rheostat. So 'potentiometers' and a 'rheostats' are different applications for variable resistors. A potentiometer uses all three terminals, and is used to control levels of potential; whereas a rheostat uses just two of the three terminals, and is used to control current.
in parallel circuit passive components such as resistor capacitor and inductor are connected in such away tht all components positive sided terminals are connected together and similarly negative sided terminals. and then positive terminal of the source is connected to positive side and vice versa.while in case of series circuit negative terminal of first component is connected to the positive terminal of the second component and so on and then source is connected
The ammeter will only read when connected properly. If the meter is connected backwards, then the meter reads the wrong way. If it is a digital ammeter then it may not work at all.
this has to do with greek myths. See the seven sisters is where all seven stars are connected.
A chord is a line segment between two points on a given curve. Basically it's two points that are connected with a line which all happens to be on a curve. Most likely a circle
A chord if not connected to the middle point. If touching the middle point than it is a diameter.
How to hook up 6 8v batteries in searise <><><> Batteries connected in series have the negative (-) of one connected to the positive (+) of the next, until all 6 batteries are connected.
To check your internet gateways and lookup all access points you are connected to you should click your start button and open a command prompt. Inside the command prompt type "ipconfig/all" without quotes and press enter. All IPs will then be displayed on the screen.