Want this question answered?
A: Any transistor of either polarity can be used as an emitter follower, The purpose of an emitter follower is to provide current to the load since it cannot provide any voltage gain
The (Class C, Common Collector) Emitter Follower is used to amplify the available current from a voltage driving circuit that might be disturbed by the load impedance. If the actual voltage value is important, the emitter follower is often teamed up with an opamp which sets the emitter voltage based on the input voltage.
Limit current through emitter, Often the resistance is the load itself. So the restatnce limits current on what otherwise would act as a voltage follower.
.7v less than unity for DC operation but unity for AC.
because it has high input impedance and low output impedance
emitter follower is a type of negative feedback ,
A: Any transistor of either polarity can be used as an emitter follower, The purpose of an emitter follower is to provide current to the load since it cannot provide any voltage gain
Connecting a resistance btw the o/p and i/p of the amplifier to increase the i/p impedance is called bootstrapping..
The advantage of the emitter follower is that it has a positive gain of 1.
I think you mean a common emitter amplifier, which is an amplifier of voltage. Emitter-follower or common collector amplifiers are used to match impedances, or to amplify power or current. The emitter-follower is a type of common emitter circuit that has a resistor between the emitter and ground. The output signal is taken from the point between the emitter and its resistor.
The (Class C, Common Collector) Emitter Follower is used to amplify the available current from a voltage driving circuit that might be disturbed by the load impedance. If the actual voltage value is important, the emitter follower is often teamed up with an opamp which sets the emitter voltage based on the input voltage.
no difference between emiter follower and source follower
Because of the geometry of the common collector configuration, changes in base voltage appear at the emitter. Said another way, what happens at the base pretty much happens at the emitter, and the emitter can be said to "mirror" or "follow" the base. The emitter is a follower of the base, and the name emitter follower appeared and was used.
A: When a signal is not amplified but simply taken from an emitter the reason is that the emitter will provide better current capabilities
The voltage gain of an emitter follower is theoretically 1. In practice, due to losses, it is marginally less than one.
It is not called that.
Bootstrapping is used in the statistics side of mathematics. Bootstrapping is a method which is used to assign measures of accuracy to sample estimates.