Because one of the Managers put Nialls Microphone to be less loud and Harry felt bad so he took nialls and gave him his!! :)
help
diffrent between modem & swicht
mabe pasenger air bag swicht of at driver side
You can use a clap switch just about anywhere in your home or office. The clap switch is a light that can come on or off and the clap of your hands.
check refrigerant level. if is ok,, replace the low presion swicht locate on acumulator.
If your talking about a motor that powers a convertible top, then... First, remove the spare tire out of the trunk, look in the far end of the trunk, where the spare tire is located, the motor will be on the right (passenger side). Disconnect the power, and ground wire, then the hydroulic lines. Pull the motor up, it is only held by plastic plugs, once removed take your new motor, and make sure it is properly filled with automatic transmisssion fluid (If your a very specific person, use Chrysler type-3 automatic transmission fluid). Wire the ground, then plug it in, place it back on the platform where the old motor was located. The motor should now function properly function correctly. If it doesn't recheck all of the directions. If it still doesn't work, check the relay swicht and it's connections, you might have to replace the relay switch.
It happen to me one time, I removed the swicht from the glove compt., run a wire from the battery ( positive and negative) to the swicht , make the contact to open it, it work fine and easy.The lock can be picked or a key fit by impressioning. This can be done by a locksmith. I have a '89 Merc. Grand Marquis and in the fuse panel there is an ignition fuse. If you jump a live wire to to that fuse it turns the on the accessory, from there you can press the switch in the glove box. if that doesnt work you can take the switch out of the glove box and put a 12v pos to it while 12v grd to the car should open it. if the cylinoid in the truck is dead meaning it wont work putting voltage to it then you would have to pick the lock, or have one made like the other reply. if you have any questions let me know.On the exterior keypad, enter your 5-digit code and then press '3' to pop the trunk. Picking the lock is almost impossible for all but the most skilled locksmiths ...and usually results in flaky lock operation after that anyway.if your keys are locked in the trunk ( i had this problem today actually while installing a few amps for my new system) you can take the back seat panel down, cut a hole in the fabric and there should be two big holes, use something long with a hook at the end (a modified coat hanger will do the trick) and shine a flash light in there, and well good luck hooking the keys lol.Another :As stated above, enter your 5-digit code into the touchpad, then press the 5|6 button. It should pop the trunk. If you don't HAVE a touchpad, you could have it picked, or you could drill out the cylinder yourself and replace it with a new one. Good luck.
if they are not on and they are supposed to be then first check ur fuse pannel and be sure that it is a good fuse and if that's not the problem then sometimes the emergency brake causes them not to come on..... so check and see if the E-brake is one click down (it is not enabled at one click) if it is then un-lock it and they should come on Was your Jeep an American one?If so you will have to take it to the dealer and have it reprogrammed