0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why would my turn signals stop working when the brakes are applied on a 2003 Chevrolet Silverado?
In all probability you have a bad ground.
What do you do if your car gauges stop working?
check your fuses first
What makes the intrument gauges stop working?
check the ground sprats
What are common causes for mechanical gauges to stop working?
Bad electrical connections.
Why causes a 2003 silverado instrument cluster to stop working?
Stepper motor failure causes the gauges to be erratic or sticking. Total power loss to the cluster can be caused by the bad solder joints on the board or the cluster power supply needing to be updated. There is also a fuse under the hood labeled IPC. Try gmgaugerepair.com also
Will the printed circuit stop all gauges from working?
Depending which circuit burned out, yes.
Tempfuelvoltage gauges stop working 2000 Chevy s10 pickup?
Check the fuses.
Will a knock sensor stop a transmission from working properly in a 1994 Chevy Silverado?
NO.
Why did my fuel and temperature gauges stop working on my 1992 Toyota corolla?
One reason why fuel and temperature gauges would stop working on a 1992 Toyota Corolla would be a short in the wires. This would lead to a blown fuse. Check the fuse and replace it.
What causes your gauges to stop working?
The year, make and model would help but with some vehicles all the dash cluster gauges are protected with one fuse.
What is wrong when your gauges on dash board stop working on your 1997 Chevy astro van?
what is wrong when your gages on dash board stop working on your 1997 chevy astro van?
Would a cancel switch make the gauges on your 1987 samurai stop working?
If the Gauges on your instrument panel have stopped working you may have had a voltage converter stop working. This device mounted to the rear of your instrument panel converts the voltage from your alternator to the voltage that your gauges run off of. You can check the fuses with a multimeter and see if both sides have voltage showing, if so then see about replacing the voltage converter.
