A few reasons.
Fluid has a much higher density, and makes it easier to apply more force to the brakes.
Fluid is much easier to contain and refill.
No special equipment is necessary to fill a brake fluid reservoir.
Air-actuated brakes are brakes where the braking fluid used is air instead of brake oil. This is not favored as air (gas) has a weaker response than brake oil (liquid) and compromises the safety and reliability of the system.
Yes, most gas stations carry a generic form of brake fluid.
Gas is compressible while liquid is not. So if you get air in your brake line, which is a hydraulic system, it will not be able to exert the needed pressure on the brake pads making them less effective.
NOTHING
you should gently press the brake pedal and gently press the gas pedal, the increase friction will dry the brakes.....
It can wear out your rear brakes prematurely if you do it for a long distance because the emergency brake pedal/handle just applies constant pressure on the rear brakes as if you were putting your foot on the brake pedal. It also kills your gas mileage.
'gas', as in 'gasoline'? absolutely not unless someone deliberately put it there. ........'gas', well,air is a gas, and yes air can be in there
gas, oil, brake fluid, coolant
No.Because it could ruin your motor.
Your screwed depending how much you got in there.
If you look on the inside of the car the brake is on your left and the gas is on your right side... And don't for get that because you will fail your driving test....
The throttle cable goes from the 'gas' pedal to the carburetor or throttle body to control the speed of the engine. On cars the brake cable goes to the emergency brake, on some motorcycles the brake cable goes to the brakes. (The main brakes for cars and some motorcycles are hydraulically operated, not by a cable.)