0
Hi I'm Patrick and I have a 1994 Plymouth Acclaim and that annoying clunking sound is coming from the rear wheels there's a bar that runs down the middle of the rail that holds the wheels together and when you go over a bump that bar smacks the canal it sits in and makes that sound so I just got my welder out and welded it to the canal to keep it from smacking.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why do you hear a clunking noise when hitting bumps?
You need struts
How do you know if rear trailing arm bushings are bad?
When your rear trailing arm (rear control arm) are bad you will hear a clunking noise when going over bumps and potholes .... This noise is louder and more noticible while you have passengers in the rear seats..... You will also hear your tires squeek a little on turns
What would make a loud clunk noise in a passenger side front tire when turning left?
If you operate a front wheel drive vehicle, the clunking noise you hear may be a CV joint bearing going bad.
What are car bushes or bushings?
Little rubber parts that help to cushion a car's suspension system, if they wear out you can hear a knocking noise when going over bumps.
You Think your BMX freewheel is making a clunking noise when you peddle. when you stop pedaling you cannot hear the clunking anymore you can only hear it when you apply pressure to the peddles.?
Chain alignment is off between the freewheel and front chainring. Also check chain tension when installing the back wheel.
What would cause 89 Mazda Mx6 clunking noise in front wheel?
either ur brakes ar gone or going so just check ur pads or ur cv joints are stuffed. u will show if u heaps a ticking type noise when u go around a corner on the side that u hear the noise from
What does it mean when you hear a clunking noise when your K1500 automatic transmission shifts gears and it appears to happen when accelerating slowly and not when accelerating faster?
A clunking noise when shifting gears on a K1500 automatic transmission, might mean a problem with the drive axle or drive shaft. Check all U-Joints to make sure they are working properly.
How do you know if your strut mounts are bad?
I have a 1990 Chevy Lumina and when you hear clunking sounds when going over bumps or dips or if you have ever replaced your strut assembly you should replace the mounts. You can buy a quickstrut online for a lumina. Front is around $180 and rear is around $80. Hope that helps!
Why do you hear a bumping or clunking noise when I go over bumpy roads in your 1998 Subaru Forester?
it could be that your exhaust pipe is lose, i saw a Forester (a litttle newer than that) with the same problem.
When i hit bumps on road on my 1996 Monte Carlo mycar front i hear a clunking noise on both sides it is not the struts they were replaced what else could it be and how would i check..?
could be the sway bar bushings going bad or if they didn't replace the strut bushings when they replaced the struts it could be them. Try checking the rear subframe bolts. I just had to replace one on my 96 after it had broken the powersteering rack. The driverside bolt was missing, i found it while replacing the rack.
How can you hear sounds around corners?
Check your sway bar rubbers in the front, there are 4 of them and they will cause a bumping and banging noise around corners and over bumps.
Translate early modern English to todays English didst thou not hear a noise?
"Did you hear that noise?" -or- "Did you not hear that noise I just heard?"
