0
First, what year? If it is the older model and there are extra lights added, then it is pulling too much current for the stator. This will discharge the battery while driving and then give less current for the electronics. If you do have the older model the stator will only be able to charge with 2 extra running lights with a MAXIMUM of 35 watts each. Yes even 50 watts each is too much. Buy yourself a L.E.D. battery volt meter, it will wire into the acc. terminal in the fuse box, the other wire is a ground. You will be able to monitor the charging system this way. If you have the older model and want to change the stator for a real alternator , then send me a message on my board. I will give you the details.
What else can I help you with?
How can I fix flickering LED lights?
Flickering LED lights can be fixed by checking for loose connections, using compatible dimmer switches, and ensuring proper voltage.
How can 2 lights be controlled by 2 switches using only 1 power source?
This can be achieved by using a three-way switch setup. The power source is connected to one switch, and then wires are run from that switch to the second switch and to the lights. This way, both switches can control the lights independently while using only one power source.
How do you remove the saddlebags on a 2012 Honda Goldwing?
To remove the saddlebags on a 2012 Honda Goldwing, first, open the bags and locate the two screws at the top rear of each bag. Remove these screws using a Phillips screwdriver. Then, pull the bags straight out from the mounting brackets on the bike, ensuring not to force them. Finally, disconnect any wiring for lights if applicable, and the saddlebags will be free.
Why would your car radio dim your dash lights?
because it is using up lots of power :)
What is the most common problem with LED lights and how can it be resolved?
The most common problem with LED lights is flickering. This can be resolved by ensuring the LED lights are compatible with the dimmer switch being used, using high-quality LED bulbs, and checking for loose connections in the wiring.
How do lights use technology?
Lights use technology by using the generators in power plants that carry elctrical currents through the power lines or cables into a metal rod whick then creates energy to produce a light.
How do dynamo lights work to generate electricity for illumination on bicycles?
Dynamo lights on bicycles work by using a small generator that is connected to the wheel. As the wheel turns, the generator produces electricity, which is then used to power the lights for illumination.
How do you get power to Christmas lights which are outside?
You can get power to Christmas lights outside by using an outdoor power outlet, an extension cord designed for outdoor use, and weatherproof power strips if needed. Make sure to keep all electrical connections protected from water and snow to prevent hazards. It's also important to use outdoor-rated lights to ensure they can withstand the elements.
What is the wiring diagram for installing outside lights?
To install outside lights, you will need to follow a wiring diagram that shows how to connect the lights to a power source. This typically involves connecting the lights to a power source using electrical cables and ensuring proper grounding for safety. It is important to consult a professional electrician or refer to the manufacturer's instructions for specific guidance on wiring outdoor lights.
Emergency lights how do they work with no power?
Emergency lights usually contain batteries which are kept in a state of charge while the power is on. When power is removed the fitting will detect this and switch on using the internal battery. Emergency light will only run for the life of the battery normally about 3 hours.
How can I control the brightness of my LED lights from a distance using a remote dimmer switch?
To control the brightness of your LED lights from a distance using a remote dimmer switch, you can install the dimmer switch between the power source and the LED lights. The remote control will allow you to adjust the brightness levels wirelessly.
How can I prevent LED lights from flickering?
To prevent LED lights from flickering, ensure they are compatible with the dimmer switch being used, use high-quality LED bulbs, check for loose connections, and consider using a voltage stabilizer or surge protector.
