answersLogoWhite

0


Best Answer

need to run diagnostic should throw a code is check engine light on?

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does 93 blazer sputter after it warms up?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What makes a 1997 s10 blazer spite and sputter?

Probably in need of a good tune up.


1990 4x4 Dakota 39 why sometimes when starting it spits and sputter badly until it warms up then is fine until you have driven 35 miles then it starts to spit and sputter wants to die?

have the fuel pess. checked


What years of s10 blazers glass fit a 1993 s10 blazer?

any s10 or sonoma up to 93 and any blazer jimmy up to 94


Will a 93 Chevy 350 bolt up to a 75 K5 blazer transmission?

yes


Why does your Chevy Tracker sputter when you get to 3k rpm in either 3rd 4th or 5th gear and when you start the Tracker in the morning it idles badly until it warms up?

Tune up time with fuel and air filters, spark plugs and wires.


The fuel pump runs but it wont start cold but it will if you keep trying 99 blazer after it warms up it starts fine?

The engine coolant sensor could be at fault.


What would cause a 1989 s10 blazer to die after it warms up?

check your catalytic converter to see if its plugged as this will cause the engine to die. good luk,ozzy


How can you tell if a torque convertor is going bad on a 2004 Chevy blazer?

How can I tell if a 1995 torque converter is going bad the tranny slips and stops when it warms up.


Will a 1984 Chevy Blazer S-10 V6 2.81 transmission workin a 1987 Chevy Blazer S-10?

yes it will up to 93 as long as they are bothe 4wd or to wheel drive


What makes my s10 blazer run until it warms up and then dies but starts after sitting for a little while?

The probable cause of your S 10 Chevrolet Blazer stalling is a bad fuel pump. The fuel pump might be working fine until it gets warm.


What should your Oil pressure be on your 5.7 93 suburban?

if i remember correctly when you first crank the engine the oil pressure should be around 60psi. after it warms up about 40psi.


93 Chevy silverado starts and runs fine until it warms up then it back fires and stalls when you give it gas?

check the egr vavle or the purge valve