Want this question answered?
The ability to compress is compressive strength but when it acts upon something it becomes latter one
nothing
Well, it would depend on the part of the bike you are talking about because there are different forces acting. For example. Spokes: There is tension (tensile strength) Seat post: Has compression (compressive strength) handlebar: torsion (torsion strength)
No. The tensile strength comes from the grain inside the metal and the ingredients used to make a certain metal. Lengths are determined by tensile strength and material advised to be used for that specific use.
compressive force
The compressive strength of Phosphor Bronze is directly proportional to the tensile strength, For example 1/2 hard phosphor bronze has a Tensile Strength of 60 to 75 ksi and a Yield Strength of 45 to 70. For typical engineering calculations, the compressive strength can be considered equal to the yield strength.
The compressive strength of natural rubber is 30MPa.
The compressive strength of 7 days shall be about 70% of the 28-days compressive strength. If your compressive strength at 28-days is 25 MPa, then the 7-days compressive strength expected to be (0.70X25MPa)=17.5 MPa Regards, Sami
Yes, the characterisrtic strength of a concrete is the same as the compressive strength
the compressive strength can be converted in to flexural strength by following formula of IS code 456-2000fcr=0.7^/- fck fcr= flexural strength fck= characteristic compressive strength in N/mm2
The ability to compress is compressive strength but when it acts upon something it becomes latter one
The compressive strength of bricks varies depending on the type of bricks and what they are used for. The compressive strength of conventional red bricks is 40 to 65 Kg/cm2. In comparison, flyash bricks have a compressive strength of 70 to 120 Kg/cm2.
Concrete with compressive strength more than 55 MPa is known as high strength concrete.It is used in the construction of bridges, dams. etc.,High strength concrete is produced by adding normal constituents of concrete with admixtures.
Compressive strength measures the largest compression force the material can withstand before it loses its shape or fails.
nothing
Minimum Compressive strength of first class brick is 10.5 MPa
Probably reinforced concrete i.e concrete with metal rods (re-bar) run through to give it tensile strength as well as compressive strength.