Want this question answered?
The refrigerant cylinder is heated in a tub of water to no more than 90 degrees F. Electric heating blankets manufactured for this purpose may also be used.
At higher temperature the vapor pressure is higher.
The lowering of the vapor pressure is a colligative property.
Osmotic pressure.
The vapor pressure of 1 m sucrose (C12H22O11) is higher than the vapor pressure of 1 m NaCl where the solvent is water Sea water has a lower vapor pressure than distilled water. The vapor pressure of 0.5 m NaNO3 is the same as the vapor pressure of 0.5 m KBr, assuming that the solvent in each case is water The vapor pressure of 0.10 m KCl is the same as the vapor pressure of 0.05 m AlCl3 assuming the solvent in each case is water The vapor pressure of 1 m NaCl is lower than the vapor pressure of 0.5 m KNO3, assuming that the solvent in each case is water The vapor pressure of 0.10 m NaCl is lower than the vapor pressure of 0.05 m MgCl2 assuming the solvent in each case is water.
When vapor refrigerant is pulled out of a cylinder the vapor is reduced and the liquid boils to replace the vapor that has left the cylinder.
Lighter, as the refrigerant is boiled off, and colder, as it has absorbed heat, and has a lesser pressure to reflect the current temperature / pressure relationship for the type of refrigerant
Lighter, as the refrigerant is boiled off, and colder, as it has absorbed heat, and has a lesser pressure to reflect the current temperature / pressure relationship for the type of refrigerant
Cycles refrigerant through the system and changes the state of the refrigerant from a low pressure vapor to a high pressure vapor.
The refrigerant cylinder is heated in a tub of water to no more than 90 degrees F. Electric heating blankets manufactured for this purpose may also be used.
high pressure vapor
Add refrigerant vapor on the low side of the system ,the compressor raises the pressure of the refrigerant on the high side of the system and lowers the pressure on the low side
Add refrigerant vapor on the low side of the system ,the compressor raises the pressure of the refrigerant on the high side of the system and lowers the pressure on the low side
Add refrigerant vapor on the low side of the system ,the compressor raises the pressure of the refrigerant on the high side of the system and lowers the pressure on the low side
The reason is that as the liquid evaporates in the tank and it cools it down and the vapor pressure (pressure in tank) is reduced and the evaporation rate decreases. Many refrigeration repair men have a bucket big enough to put their tank in and add hot water to keep the tank warm and get the freon to evaporate faster to speed up their project.
The reason is that as the liquid evaporates in the tank and it cools it down and the vapor pressure (pressure in tank) is reduced and the evaporation rate decreases. Many refrigeration repair men have a bucket big enough to put their tank in and add hot water to keep the tank warm and get the freon to evaporate faster to speed up their project.
Yea