answersLogoWhite

0


Best Answer

Need to replace fuel pump relay.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does the fuel pump run continuously on a 1991 suburban when ignition is turned off?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the BDCT ignition timing degree on a 1991 Chevy Suburban 5.7?

you should set it at 0 degrees btdc


Why would nothing happen when the key is turned on a 1991 Chevy Blazer?

Probably ignition switch. Have it checked out.


Can the key be pulled out of a 1991 BMW while in gear and what happens if it can be?

In my 1991 525i auto it can. The ignition turns off and the steering will lock if turned. Bad idea.


What should be checked when the AC is turned on and there is an electrical smell?

I had this problem in my 1991 Suburban. It turned out being the A/C, Vent, Heater switch having burned contacts. Had the switch replaced and smell went away.


What transmissions will fit in a 1991 Chevy Suburban?

One transmission that will fit a 1991 Chevy Suburban is a 4L80E transmission.


Climate control blower wont shut off when the turned ignition is turned off on a 1991 corvette.?

Climate control blower motor was the fix. The part cost 441 dollars.


When was Suburban Commando created?

Suburban Commando was created on 1991-10-04.


What is the transmission in the 1991 suburban with overdrive?

700R4


Does a 1991 suburban have a cabin air filter?

NO.


Where can you find a wiring diagram for a 1991 Suburban?

You can find the wiring diagram for a 1991 Suburban at various auto part stores. You can also check in the owner's manual.


How do we turn off the alarm system on a 1991 Toyota Camry?

The 1991 Toyota Camry has an alarm system button below the steering column. The ignition must be turned on and the button pressed for 30 seconds to deactivate the alarm.


Where is the ignition module on a 1991 suburban?

It is inside the distributor, If you look at the right side of it you will see some electric wires and they are hooked to the module. Just remove the cap and then 2 screews that hold the module on the base of the distributor.