0
Why does the shape of an ointment tube change when you squeeze it?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
The shape of a rain gauge is a?
A cylinder or a tube
Why liquid can move the shovel of the rubbish mover?
because liquid can change shape and flow along pipes into the tube but it can't be squashed so it is able to move the piston out :)
Are your eyes test tube shape?
No, eye balls are circular.
What is the Shape of a microscope?
The microscope doesn't have a cirtain shape but it is made up of a veriaty of shapes. the tube you look into is a cylinder shape the base is a square/rectangular shape and the platform is a square.
What tube is responsible for the equalization of pressure when you change elevation?
Auditory tubeThe auditory tube which used to be called the Eustacean tube.
How long after opening should a tube of ointment be discarded?
Six months
How do you administer erythromycin eye ointment to a newborns eyes?
It is easier if you have two adults for this. First, wash your hands thoroughly if you wil be administering the ointment. Make sure the outside of the tube is clean also. While the helping adult holds the infant, cradling the infant's head in the crook of an elbow to stabilize it, ideally with the child's face turned slightly outward, away from the body of the bradley cradler. Uncap the tube of ointment and set it on a clean tissue. Expel a small amount of ointment from the tube to clear away any residual ointment that might be contaminated from a precious application., Use the thumb and index or middle finger of one hand to gently hold an eye open while carefully, steadily use your better hand to bring the tip of the tube within half a centimeter or about a quarter of an inch away from the inside corner of the eye. Begin gently squeezing the tube until the fresh ointment starts to exude, letting the ointment fall into the inner corner. Now, without putting the tip of the tube any closer to the child's eye draw the tube too toward the outer corner of the eye while simultaneously squeezing the tube to keep the ointment coming at the same rate as that required to prevent breaking the flow of the ointment, of possible. The ointment should fall into and across the entire eye from corner to corner. Stop when the ointment has reached the outer corner and stop squeezing the tube. Do not simply draw the tube away from the child's eye at this point, because you risk pulling the bead of ointment out of the eye. Squeeze enough extra ointment as you pull away the tube from the eye that there is rom for you to use a very clean fingertip to break the extended bead from the tube tip. It is okay if this extra ointment falls onto the child's skin around the outer eye. Use a clean tissue now to carefully wipe away this extra ointment so the bead ends just inside the outer corner of the child's eye. You may release the child's eyelids and the child will blink immediately. Try to do all of this fairly quickly, but don't sacrifice care for speed. Repeat with the other eye. You may find it best for your helper to change the child's position to the other side, again putting the other eye closest to you and away from the helper's body. Don't be alarmed if the child's blinks seem to push some of the ointment out. Enough wil stay in to do the job. Also, like most mothers, I was able to do things without a helper with practice.
What is a dropper and what are its uses?
A dropper simply is a small tube with a air-filled bulb at the top. You squeeze the bulb at the top and whatever substance the tube is submerged in, it will be pulled up into the tube. After that, you lightly squeeze the bulb again to release the substance in the tube out.
Can you give me example of squeeze in a sentence?
I squeezed the toothpaste tube to get the last bit out.
Why tube light always in round shape?
because it is focused on a straight way and it cannot change its direction
How do you get a magic ball?
If you mean the "magic ball" as in the touchable bubbles that you blow up from a tube? You buy the kit witch will come with a blowing tube with a yellow side and a red also it will come with a tube in the shape of toothpaste first squeeze some goo from the tube that is in the shape of tooth past and push on the tube then rap some glue around the yellow end of the tube then back sure there is a dot on top then blow slowly from the red end after that when you have it the size you want the balloon pinch the balloon were the tube is and pull off then make sure it is no hole's and then PLAY!!!
Why do you have to squeeze the toothpaste tube?
so it can come out cause it has zero force
What is the percentage strength of an ointment containing 300 mcg of drug y in a 10g tube?
0.15%
What kind of shape is a tube?
A tube is a hollow cylinder.
What do you call a plastic tube that takes in water and you squeeze out little droplets?
A syringe.
What is a ribbon when applying ointment to eye?
a strip about 1/3 inch long and the size of the opening in the tube. Squeeze in eye lid bottom by pulling down and forming a pocket. Hold eye shut allowing medicine to stay in contact with the eye. OK to blink eye after 1 minute.
What is a shape of a clarinet?
The clarinet has the shape of a cylindrical tube.
