0
fets are used in linier ic's to
1)to provide large resistences
2)increase input resistence
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is the Difference between linear IC and digital IC?
Both linear ICs and nonlinear ICs has an output voltage which is dependent on the input voltage. However, the difference is that linear ICs produce an output voltage which increases or decreases at a "fixed rate" relative to the input voltage. Nonlinear ICs do not do this. A voltage regulator may be considered nonlinear because as you increase the input voltage the output will climb at the same rate (just like linear ICs), however, once the input voltage reaches a particular level point, the output no longer increases as you increase the input. This is at the point where regulation begins. The nonlinear IC no longer changes its output at a fixed rate relative to the input.
Why bjt is not used of fet in building logic circuit?
land pe char hai
How does the Analog multiplexer IC-4051 works?
I think each channel acts like a drain-source path of a FET switch,whose resistance changes from very high to very low. Yet the Drain - source are almost isolated from gate. It seems internally the a.multiplexer contains such FETs. And depending upon the channel selection by digital pins a0..a2 certain single path is made low resistance
What is the Bell Biv Devoe used for?
This is a mus ic group. It is made up of three boys named Bell, Bivins and Devoe but then the Bivins got shortened. They released an album in 1990. The group is used for entertainment.
Why biasing is needed at all?
Biasing is used in a transistor amplifier circuit in order to place the transistor as nearly as possible in the center of its linear region. Transistors have cutoff, linear, and saturation regions. Too little bias current, and you enter cutoff - Too much, and you saturate. Both conditions cause distortion when you attempt to use the transistor as an amplifier, as opposed to a switch.
What are the Examples for linear ic and nonlinear ic?
op amp linear ic 7805 non linear ic
Difference between linear IC and Digital IC?
In linear IC'S the output voltage is very according to input voltage In digital IC's the output voltage is either high or low
Why you use FET?
FET's improve the switching frequency from KHZ to MHZ.. FET can be used as temperature sensor.. and mosfet is used as a switch..
What does lm stands for in lm741 ic?
linear monolithic
What is the meaning of LM in LM 555 IC?
It's a prefix of the IC products of 'Linear Monolithic' category of National semiconductors.
What is LM in LM series IC?
The "LM" stands for Linear Monolithic" and is just part of the part-number that National decided to use for this famous timer IC. The LM prefix is still used for a lot of medium complexity analog chips, like regulators and op-amps.
What does LM stands in LM386 IC?
LM stands for "Linear Monolithic"
Full form of lm as in ic lm-324?
Linear mode
What does the acronym FET stand for?
FET is an acronym that is used in a variety of situations including education, medical, business and electronics. The abbreviation FET stands for Field-effect Transistor.
What is Linear system in electronics?
A linear electronic device is one where output is linearly proportional, in some way, to input. An example is an amplifier. A non-linear device is one where the input drives the circuit into some kind of saturation mode. An example is a switch, such as is used in TTL IC's.
What is a IC holder used for?
For an IC chip
IC 74180 is used for?
ic 74180 is used for parity genrator
