The two main reasons are (1) the ease and efficiency by which a.c. voltages can be changed, using Transformers, and (2) the ease and efficiency by which a.c. can be changed into d.c., using rectifiers.
The power source is AC. Hence AC is used. DC application is limited.
DC is used for extra-high voltage transmission systems, as there are less losses with DC than with AC, and no synchronising problems.
It is used to detect very small DC currents only. For AC signals Detectors are used.
The number of Joules (energy) is the same as dc provided the RMS values of the ac quantities are used.
The 6013 Rod can be used on either ac or dc arc welders, at around 90-120 amps depending on your settingsTucson Direct
Yes
A DC/AC power inverter is used to convert DC, the power that comes from a car's battery, into AC, the kind of power that is supplied to a home and used to power larger electronics.
Junction diodes are used for rectifying ac into dc.
The power source is AC. Hence AC is used. DC application is limited.
A DC to DC converter is basically a type of switching power supply. The switcher converts the input DC to AC. A transformer is used to convert the AC to the desired voltage. A rectifier, filter, and optional regulator is used to convert the AC back to DC.
DC is used for extra-high voltage transmission systems, as there are less losses with DC than with AC, and no synchronising problems.
simple capacitor can do this job (to block dc and pass ac).
AC...
It produces alternating current AC. It is cheaper to build than a DC or an AC - DC welder. Most electrodes can be used with DC. Some can be used for both. Very few are AC only. DC produces a smoother arc, is easier to strike an arc and most machines in industry are DC. Surprisingly a lot of AC machines are on farms as they were cheaper to buy.
No ... AC means Alternating Current - DC means Direct Current. DC is used mostly for electronics and for voltages within our vehicles. AC is used for motors and for our household appliances and lamps.
Because, the commutator segments are used for converting AC to DC.
AnswerThere is a hard rock band called AC/DC .In electrical jargon, AC is short for alternating current and DC is short for Direct current.