There are a few reasons. crankshaft position sensor, faulty fuel pump, fuel pump regulator, throttle position sensor, oxygen sensor. Need to have it diagnosed.
1993 Volvo 850 : Where would a cold start injector be located - only see 5 injectors. ... 1995 Chevrolet Lumina : 1995 Chevy lumina van. motor dies at low speeds. more ... 1992 Ford Explorer : what would cause high oil pressure blow by on my 92 ... Thanks for your hard work, and impressive contributions to this ...
The clutch might not be completely disengaging.
what other hard tops from convertables will fit a 99 Chevy cavalier
If there is no check engine light illuminated, start with the basics like a good tune up.
check compression
Umm..the same way you took it off..jk...there is only 2 bolts holding it. If it is hard to go in then the boot ( that little piece of rubber) is blocking it
This is a very hard job without the proper equipment. Not recommended for the novice. It will also depend which bearings you are asking about, front or back. Both equally hard to do.
My 1991 740 volvo turbo doesnt start specially during the morning.Is it comes with a cold start valve?
Check the map sensor.
More than likely there is a speedometer gear on your transmission that has a cable leading to the speedometer. These thiongs go out as they are usually driven from the gears in the tranny via plastic gears in the module. It is not hard to remove-one or two small bolts and it should slide right out. Their also very cheap to buy and replace. Good Luck!
Needs a tune up?
The fuel pump in a 94 Lumina should not be running with the relay removed. The relay could be mislabeled, as the fuel pump is still getting power through a relay.