0
Why is it difficult to remove an air sucker pressed to a surface?
Wiki User
∙ 11y ago
it is hard to remove since the air outside the pump cannot enter or amalgamate witht the air that exists inside the pump.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Why rubber suckers sticks on smooth surfaces?
The sucker is dish shaped, when pressed against a smooth surface the air is forced from beneath the sucker.The rubber makes an air tight seal and the air pressure outside is greater than the air pressure beneath the sucker, thus forcing the rubber sucker to 'stick'.
How do Cartesian robots work?
Yeah right, like I'm going to give u an answer - sucker!
How do you stop a ghost?
To stop a ghost is a vacume sucker and a cross neckles to protect u. Try too talk too the ghohst to see wat it wants. If it wants to kill u for wat u done use the vacume sucker and that's it bye =)
What tools did Thomas Edison use for the light bulb?
He used the sucker to get the air out of the light bulb and the rest I don't no.
Why does a soft drink rises when sucked with a straw?
As you suck on the straw air is removed from the inside of the straw and the air pressure within the straw is reduced. Once the straw's air pressure is reduced past atmospheric pressure of about 760 mmHg, the Patm forces the drink up the straw and into the sucker's mouth. Gases move from high to low pressure areas until equilibrium is reached.
Why rubber suckers sticks on smooth surfaces?
The sucker is dish shaped, when pressed against a smooth surface the air is forced from beneath the sucker.The rubber makes an air tight seal and the air pressure outside is greater than the air pressure beneath the sucker, thus forcing the rubber sucker to 'stick'.
What is the principle behind rubber sucker?
It has a flat surface which can stick on smooth surface.
How do you remove the rear quarter panel on a 1996 Mitsubishi eclipse?
the sucker is welded on, you gotta remove the bumper and tail lights, and start drilling away at the welds
How do you type sucker on keyboard?
sucker
What is good for removing big lumps from a liquid?
you use a sawref this is a sucker machine which will remove the big lumps
Why a sucker stays in place on a flat surface?
because its not sphere-shaped so it wont roll and if it was a shere it still wouldn't because of the stick...
What is a solder sucker used for?
To remove melted solder, either as clean-up from a poor solder job, or in preparation for removing a component.
What is a typical day of a basketball pro?
a sucker a sucker
What are the parts on the sucker on a squid?
Hooks and sucker rings.
What does the phrase 'I'm a sucker for...' mean?
A "sucker" is a gullible person, as in "There's a sucker born every minute". "I'm a sucker for .." means one is vulnerable to or easily attracted to ...
When was Sucker barb created?
Sucker barb was created in 1860.
When was Longnose Sucker created?
Longnose Sucker was created in 1773.
