It could be low on coolant. It could have air in the cooling system and needs to be burped. It could be a fault low coolant switch or the associated wiring.
There are 2 coolant locations.
1) there is an expansion tank (white plastic) connected to the radiator filler neck via a hose.
2) There is the radiator itself. Check the radiator by opening the radiator cap when the engine is cold. (no pressure in cooling system. ) Visually examine level or coolant -- should be at or near radiator cap neck.
3) on a '96 the coolant sensor is located on the left side of the radiator about 6 inches down from the top.
A stop leak additive or debris in cooling system will fake out the sensor causing the light to flash. Solid on, coolant may actually be low in the radiator and the cooling system will need to be bled of trapped air.
On the '96 there are 2 locations to bled with brass plug/screw.
One in the pipe sending coolant across the front part of the engine.
The second is a plug in the intake manifold on the right, topside.
If the hose between the coolant recovery tank and the radiator leaks, then air will get into the system. Also if water pump seal fails, same problem.
just like was said,coolant low or bad switch,or needs air bled from the line
coolant sensor replacement need it
Check your coolant level...
Either low coolant level or the engine is overheating.
The service engine soon light on an Oldsmobile Cutlass Supreme notifies the driver that it is time to change the oil. It is trigger around the 3,000 mile mark at regular intervals.
I Dnt know
flashing blue means you have an electrical issues with the coolant sensor. you probably have a bad sensor that needs replacing in the coolant bottle hope that helps Phil
change your thermostat.
Mine went nut. After I filled up the coolant reservoir, the D light stopped flashing. Good luck!!
its a dance party
if the coolant light is flashing red it means it's overheating (DO NOT DRIVE), check coolent level "if level is fine", it may be your thermastat. if coolent level is low check your coolent hoses. (allow engine to cool before checking)
Switch the ignition off and start the car again.The light will then stop flashing.