0
Why is potassium manganate put in the burette during titration experiment?
Wiki User
∙ 11y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What tools are used during and acid-base titration experiment?
Burette Methyl orange Phenolphthalein Pipette
What tools are used during and acid base titration experiment?
Burette Methyl orange Phenolphthalein Pipette
What apparatus is used in titration?
A burette, a pipette and conical flask
What are sources of error in a titration?
parallax error - reading of volume of burette
What is the titration flask?
It is the conical flask in which the solution from the burette flows into and which you add the indicator into.
What tools are used during and acid-base titration experiment?
Burette Methyl orange Phenolphthalein Pipette
What tools are used during and acid base titration experiment?
Burette Methyl orange Phenolphthalein Pipette
What apparatus is used in titration?
A burette, a pipette and conical flask
What are sources of error in a titration?
parallax error - reading of volume of burette
What is a burette?
A burette is a glass tube with fine gradations and a stopcock at the bottom, used in laboratory procedures for accurate fluid dispensing and titration.
What is the titration flask?
It is the conical flask in which the solution from the burette flows into and which you add the indicator into.
Why it is preferred to take acid in burette during acid base titration?
The burette can be filled with either acid or base. The acid will go into the burette only if you want to titrate a base , i.e. you don't know the concentration of the base and want to find out. The solution of known concentration goes always into the burette (in order to be able to measure the volume taken to complete the reaction) and so if you wanted to find out the concentration of an acid you would put the base into the burette.
Why is it advisable to remove sodium hydroxide from the burette as soon as possible after titration?
Sodium hydroxide, particularly highly concentrated sodium hydroxide, can dissolve glass if left sitting long enough. Therefore, if you leave the sodium hydroxide in the burette after finishing your titration, you could increase the volume inside the burette from the glass being dissolved from the inside out. This would make the burette measure the titration volume inaccurately and would invalidate the results of future titrations done with this instrument.
What do you use a burette for?
The pricipal use is in the volumetric titration - a method of quantitative chemical analysis.
What is the purpose rinsing the burette with distilled water during titration?
Burette is used to measure the accurate value of taking products and we will calculate the lower minuscus and upper minucus of the burrete that's why we using the burette
What is the advantage of using burrette compared to using measuring cylinder?
A burette is preferred for titration over a measured cylinder because it can give a finer volume reading. You can also add in all your chemicals at the start of the experiment.
What is the precaution steps for titration?
Ensure the burette is vertical Titrate slowly when reaching the end point
