hyber process run at 450 degree because you have to fail in examination so it better for you not to ask question
The Haber process is run at around 450 degrees Celsius to provide enough energy for the nitrogen (N2) and hydrogen (H2) molecules to overcome their activation energy and react to form ammonia (NH3). This temperature is a compromise between achieving a high reaction rate and minimizing production costs associated with operating at higher temperatures.
Chlorine would condense to a liquid at the highest temperature of the three gases mentioned. Chlorine liquefies at -34.6 degrees Celsius, compared to Fluorine (-188.2 degrees Celsius) and Ammonia (-33.3 degrees Celsius).
The purpose of a trial run is to test a process or system in a controlled environment before it is fully implemented. This allows for any issues or errors to be identified and addressed before they can cause problems in a live situation. Trial runs help to improve efficiency, accuracy, and effectiveness of the final implementation.
Coal is formed over millions of years through a process called coalification, which involves the decomposition and transformation of plant matter under high pressure and heat. Since this process takes a long time, it is not possible for humans to create coal in a short period of time when we run out. Additionally, coal reserves are finite, so eventually, it will no longer be available as a resource.
Uranium-235 is the primary chemical used in nuclear power plants to produce energy through a process called fission. When a uranium-235 atom undergoes fission, it releases energy in the form of heat, which is used to generate electricity. Control rods, such as cadmium or boron, are also used in nuclear reactors to regulate the fission process and ensure safety.
When water passes through activated carbon, the carbon absorbs impurities, odors, and chemicals from the water. This process helps to purify the water by removing contaminants and improving its taste and odor.
because in this process a mixture of nitrogen and hydrogen is heated at 400 to 450c
The Haber process is run at 200atm insted of 1000atm (because it would be too expensive to build a plant that would withstand pressures of over 1000 atmospheres, for example). Hence the 200 atmospheres operating pressure.
A healthy catalytic converter will be hotter out the back outlet than the front inlet after a good highway run. Average temp should be aprox 450 degrees at the front inlet to 700 degrees out the rear.
This size unit is enough to cool a room 450 square feet which gets a lot of sunlight; air conditioners are rated by BTUs not degrees of cooling, you run it until the room is the temperature you have chosen.
450
450 feet
The correct phrasing is "the process will be run." In this case, "run" is the past participle form of the verb and is used to form the passive voice in the future tense.
Preheat your oven to 450 degrees, place two 5 pound stones on the top rack and bake them for 20 minutes. Remove them barehanded and run as far as you can before you have to let go. Repeat daily.
You will not really gain any H.P. It might make the engine perform better, but that depends what the timing is set at now. Ex: I have a 400 cu. in. Chevy small block, 450 h.p on the dyno, 400 foot lbs. torque. With say 89 octane the timing has to be set at 30 degrees, or the engine will run on when you shut it down. With say 94 octane or better, the timing can be set at max which is 36 degrees. The engine will be quicker and run much better, but in either case, I will still have 450 h.p.
The DS450 completely stock will run 73MPH @ 10500 RPM topped out.
45 degrees.
As far as my nowledge there is not one.the only way there could be is to run off the starter but i have owned a good handfull of Yamaha 450 and the wr450 nor the yz450 have revers.