it shouldn't be. and no it will not work
yes just drill a hole if you need to
The screw head is larger to prevent the screw from pulling threw the hole made by the shaft
Any head will fit on any shaft. But if you but a head on a shaft that is a different brand than the shaft, you may need to drill a new hole into the shaft. The only exceptions are the STX Crankshaft shafts which need certain heads.
Yes, you just need to drill a ne hole(easy).
If the head fits then you just need an electric drill and put the head on. Once you have the head on, drill a screw into the shaft through the hole while applying pressure on the drill. If the head does not fit, Then put a pot of water on the stove to boil. Once it is boiling, dip the bottom of the head into the boiling water for about 8 seconds and then squeeze it onto the shaft. This worked for me with a metal shaft so you could try it with a wooden shaft. Instead of all this you could go to your local lacrosse shop and ask them to do it but it will cost you $$$.
Yes, It may take a little bit of pressure, but it eventually will slide on. If you have trouble, run the throat (bottom part of head that connects to shaft) under some hot water, and then try sliding it on (this will soften up the plastic)
Normally the lacrosse head is screwed into the shaft. You can therefore use a screwdriver to unscrew the screw connecting the head to the shaft. once the screw is removed you will be able to remove the head from the lacrosse shaft
well it may depend on the type of stx head or warrior shaft,,, usually they can but you may have to drill a new hole. i had an stx proton power on my warrior krypto pro, and all i had to do was drill a new hole.... hope this helped :)
Yes. You may need to drill a pilot hole into the shaft to affix the head.
Yes, the safest way is to drill a small pilot hole first. Do not make your new hole in the same section as the old one, turn the shaft around, or flip it over.
yes but most likely you will have to work to put it on.. IE push hard then take it off and put it back on. the holes will also most likely not line up so you will have to drill a new hole
any mens head can fit on any mens shaft. i put warrior, brine and gait heads on STX and harrow shafts all the time. the only thing that is different between different brands is where the screw hole is located but alot of people just tape their heads on their shafts anyway. i however are one of those people who like to screw their heads on their shafts but i have found that i can drill a new hole myself by using a 1/8 drill bit. it makes the perfect sized hole for the screw. please add me to your saved sellers on ebay, ihave awesome deals on the top lacrosse gear