answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2013-08-30 22:06:05
2013-08-30 22:06:05

The security light comes on after you changed the keys in the ignition from the off position to the on position as a confirmation that the electrical components in the dash board are working. It is nothing to be concerned about.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


A flashing Security light is indicating that the security system on your car is active.


if you're getting absolutely nothing, and the security light is on, then it is a bad VATS system. you need to replace the ignition tumbler and get new keys made.



Turn the ignition switch into the "On" position and leave for approximately 30 minutes. The security light will remain flashing for approx. 10-15 minutes. Then, will turn off and the modulator will reset. Then, turn the ignition to the off position take the keys out and the reinsert and start the car. The "security" light at this point will be off. Due to the security modular, the fuel pump is being shut off to control the theft of the car.


Lost ignition keys for newer vehicles can be obtained from the vehicle dealership. Lost keys for a 1978 Honda Accord will require the replacement of the ignition.


They do have ignition keys. You must have the key on your person for the start button to work.


it normally tells you that you have the door open or you're keys are still in the ignition barrel


There is a long black thing on your keys, shake your keys in the ignition and dash should light up .


Why won't the keys in the ignition turn on a 1992 grand marquis?


Ignition keys have changed over the years. You can no longer go to the hardware store and get spare keys made. New vehicles require computer chips inside the key before the vehicle will start. These must be purchased at the dealership. The cost for these keys may range from $75 up to $125 per key.


Yes, originally the door and ignition keys are the same. but if you have to replace your ignition / steering column, you will have a different (re-keyed) key for the door and for the ignition.



it means that either your keys are still in the ignition after you turned the car off, or your headlights are on, or you need to shut the door or trunk for it to stop blinking but wont ever go off




You do not need a key to replace the ignition switch.


It means the keys are still in the ignition. This light usually illuminates after you've opened a door.



If you lost the keys and you can prove that you are the titled owner. The Chrysler dealer can order an ignition key with the VIN number. You may have to have the door locks replaced, if the door key is different from the ignition key. If that fails, try an auto electric shop to get the locks changed, maybe even a locksmith.



Keys are not necessary, but is not a DIY procedure. Contact a locksmith or mechanic


Not the starter, but the weight of the keys can be damaging to the ignition key cylinder.


you will have to replace the complete ignition switch with a new one.


When your car is serviced at a non-vw garage or at home by yourslef, the ecu doesnt know its had a service, so the service indicator stays on. To reset it: -(with the ignition off and keys out) press and hold the mile reset button -turn ignition on -wait until the display goes like '--' -turn ignition off and keys out and release button


one with the doors unlocked and the keys in the ignition



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.