answersLogoWhite

0


Best Answer

Additional shut off valve, below sink or in basement. Incomplete pipes not tied into bathroom sink line.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why is there no flow from bathroom sink if water supply is on?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Engineering

When using the bathroom faucet sink water is not draining and in the master bathroom sink water is backing in there also?

Snake your drains


Why is there no running water in the bathroom sink?

The water could be turned off under the sink or at some other point in the supply line.The pipe could have become clogged with rust or other impurities.The faucet could be operating improperly and not opening. (A washer that has broken and blocked the piping.)The screen filter over the faucet could be filled with small gravel or rust.If you have no water flow it is the aerator or both pipes are frozen (located on an outside wall)The possibilty of both H&C being blocked with internal corroson is NIL for both to stop the supply at the same time


Why does a bathroom sink drain get stopped up?

Most times a bath / lavatory sink will stop water flow because of hair that accumulates in the trap of the drain ,The trap is the upside"S"underneath the sink ...Try using liquid plumber foaming pipe snake that you can buy at your favorite grocery store.


Average size of a bathroom sink?

An average bathroom sink is 6-7 litres


How do you remove a bathroom sink?

Place some towels under the sink to catch any drips while doing this procedure. Turn off the valves under the sink that supply water to the faucet. Disconnect the supply lines to the faucet. Place a bucket under the drain pipe. Disconnect the p-trap. Drop the trap into the bucket. The mechanics of the sink have been disconnected now the sink needs to be removed. If it is a pedistal sink, look for screws or bolts unterneath by the faucet. I've installed in vanity, those sinks are usually glued to the cabinets. Use a prybar to separate it. http://www.lets-do-diy.com/Projects-and-advice/Bathroom/Basins-and-bidets.aspx

Related questions

New bathroom sink water flow poor?

remove aerator


How much water does a bathroom sink use?

Bathroom sink use 5 liters of water.


When using the bathroom faucet sink water is not draining and in the master bathroom sink water is backing in there also?

Snake your drains


How do you turn off the water to remove a bathroom suite?

You will have a shut off for the commode and each sink. The only way to turn the supply to the shower is to turn off the supply to the entire home.


Why does the water in your bathroom sink faucet flow water towards the back of the sink istead of straight down It just started doing this?

The mesh filter at the head of the faucet is clogged. Take it off, clean thoroughly and re-install.


What causes a decrease in water pressure in just the the upstairs bathroom sink?

Unscrew the aerator from the end of the faucet where the water comes out and clean the screen. Sediment build up slows the flow.


How many pipes needed for a bathroom?

Supply lines- Hot and cold water for each sink, bathtub, Jacuzzi tub, and shower. Cold water for each toilet. Drain lines- one for each sink, bathtub, Jacuzzi tub, shower, and toilet.


How can you repair the hot water knob on your bathroom sink if it won't turn to the point that you can run hot water from the sink?

Replace the faucet.


No water flows from new bathroom faucet?

Did you remember to turn the supply line back on? Was there a plug that needed to be removed before connecting it?


How does water come out from a tap?

The average kitchen faucet in a house will supply 2.5 -3 gallons per minute at 50 PSI. That is an average hose working pressure in north America. A large bath faucet will supply 3 + gpm and a single lever bathroom sink faucet will be about 2 gpm.


Why is the water flow in your new bathroom faucet low when you turn on the hot water?

Check the shut-off valve for the hot water side that's under the sink and make sure it's fully open.BECAUSEThe installer did NOT remove the aerator prior to the installation and the flow restrictor is blocked


Explain the difference between direct and indirect cold water supply?

the difference are as follows. the direct water supply comes from the outside main water supply directly into the sink. the indirect water supply has mains cold water collected in a cistern which in turn supplies water to the sink.