Heating slowly will help with uniformity across the test specimine. The temperature should be uniform (about the same) throughout the entire product. If it is not, a reading could be false. If you're taking a measurement in one area, there may be a temp difference between the area you're testing and the area that you are observing...
The water bath provides heat, which speeds up the reaction.
The water must be heated.
Yes, it gains kinetic energy, for instance, when water is heated into water vapours the molecules of water vapour move faster than the molecules of water. This is because the water vapour has more kinetic energy than water.
All waste from the toilets are stored in tanks that must be emptied on the ground. The waste water from the sinks, however are dumped in flight. The water is expelled from heated tubes that protrude out from the belly of the plane. The tubes are heated to prevent the water from freezing as it is being dumped.
In a beaker, sugar is dissolved in water, and then the water is heated and evaporates. The sugar is recovered, and heat is again applied. Vapor is released, and the material in the beaker changes from white to black. What must you know to determine if a chemical change occurred? CO2 (carbon dioxide) CuO (oxidized copper) H2O (distilled water) H2O2 (hydrogen peroxide) NaCl (sodium chloride)
A water bath must be used while heating ethanol and acetone because the temperatures at which they can be heated might break the container they are heated in. Some metals are also heated this way.
The water bath provides heat, which speeds up the reaction.
The water must be heated.
1. Never heat alcohol directly on naked flame 2. you should take a beaker with boiled water in it and then place the alcohol with the test tube in it 3. you should wear goggles while heating alcohol. 4. never smell the alcohol directly after heating
To stop water vapour escaping
Yes, it gains kinetic energy, for instance, when water is heated into water vapours the molecules of water vapour move faster than the molecules of water. This is because the water vapour has more kinetic energy than water.
To remove the water of hydration. the loss of weight will be the weight of water present in the original salts.
No; water (as gas) must be cooled to become a liquid - this change is called condensation..
I think it has something to with your pipes not your water. Your pipes are must probably rusty and it is coming out in the water.
Yes, you must clean bath tub mats as water trapped under can produce mold in less than 24 hours.
One must first cleanse oneself with soap and water using the detachable shower heads located near the bath before entering the water. Once clean (including rinsing away all soap/shampoo), you may enter the bath. Typically, you should not let your hand towel touch the bath water. You may put it on your face, or thereabouts.
Below 100 °C.