answersLogoWhite

0


Best Answer

Its Bad... take the belt off via tensioner pulleyand see how much play is in the A/C pully pretty loose. easy to fix 1 8mm bolt in the centerto take off the pully buy new one save that plastic spacer if not shot can get at dealer. snap ring holds in the cluth pull it out put the new one in reassemble no need to let out the coolant, R134a your welcome

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why noise comes from ac compressor clutch on sable?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can AC Clutch be replaced without physically removing the Compressor on 1997 Mercury Sable?

The AC clutch cannot be replaced without physically removing the compressor on a 1997 Mercury Sable. The compressor and magnetic plate must be removed before you can access the clutch.


What is estmated cost to replace ac clutch in 05 Mercury Sable?

$250 to $350 range. get it fixed before it messes up the ac compressor and now you're looking at the $600 to +$1000 range


What tool is needed to remove air compressor in 98 mercury sable?

There is no Air Compressor on your Sable unless it has air ride. If you are referring to the Air Conditioner Compressor, then know that releasing refrigerant into the atmosphere is illegal. Replacing the compressor is a job for a professional with the proper tools to perform this repair.


The ac compressor seized up on your 1993 mercury sable Can you get a serpentine that is shorter and skip over the ac entirely?

The short answer is "NO." They do not sell shortened belts. To fix the problem, you can do two things. Remove the a/c clutch with a puller and install a new one (a real pain!). Or, replace the a/c compressor.


Why is my Mercury sable making scraping noise in rear wheel?

Frequently the scrapping noise indicates that the brakes need repairing.


Where is the air compressor located on a 1999 Mercury Sable?

Right side lower belt driven accessoriy


How 2000 Ford Taurus Ac clutch replasement?

If the clutch has failed, it's probably time to replace the entire compressor. I wouldn't recommend just replacing the clutch, but if you decide to, you may need a specialty puller. Most auto parts retailers will lend/rent/sell you specialty tools in the hopes of selling you the parts for your car. If you tell them what you're trying to do they'll also give you some specific instructions. I own a 2001 Ford Taurus and a 2000 Mercury Sable with 3.0 L 12 V and a 3.0 24 v Duratech AND live in Las Vegas so I went though replacement of a compressor or two. It makes absolutely no sense to just replace the clutch since it's virtually impossible to remove the clutch from the compressor without removing the unit from the vehicle. This means that you will have to clear out the system and then refill it anyhow, and chances are that if the clutch went, the compressor is next. A NEW compressor at Autozone is about $250 with a new clutch. DO NOT get a remanufactured unit since they are usually good for only about a year before they fail again. This is from experience and after two reman units, I finally bought a new unit and two years of Las Vegas summers and everything is fine.


How do you diagnose brake problem on a 1995 mercury sable?

What kind of brake problem(noise,pulling)?


What kind of noise does a bad front wheel bearing make 2000 sable?

It will rumble and increase with speed.


What causes a humming noise when you accelerate The noise stops when your foot is offf the gas pedal The car is a 1999 sable with 84000 miles?

wheelbearing or cv axle enjoy


Mercury Sable fuse box?

On most Mercury Sable and Ford Contours, the fuse box is located on the firewall just above the brake or clutch pedal. It has a cover that is very easy to remove and the fuses are inside.


There is high pitch noise from the hood of my car - mercury sable 1998. Trends to get worse at higher speeds.?

Could be a bad bearing in one of the belt driven accessories i.e. Alternator, Water pump, A/C compressor etc. Two things come to mind: The belt may be loose or a bearing may be bad on one of the pulleys. Either would cause a high-pitched whineing noise.