If it has an automatic transmission one is the Detent(kick down cable) I have a tool that is used to force spray lube down the cable there at cycle shops, worth a try
You have to remove the throttle body because it's blocking one of bolts. Remove the hose connecting the throttle body and the air filter box. When you get it done, you have access to all bolts (and usually one nut). Disconnect harnesses and spark plug wires from the coils. Coils are attached to a special holder using two bots per each coil. Remove the holder, replace coils. Installation is reverse to removal.
Use the ashtray.
To remove the rear cup holder on a 1998 Toyota Corolla LE, first remove the seat. Then remove the four bolts holding the cup holder housing.
To remove the dash cup holder in a 1993 Toyota pickup, first, ensure the vehicle is off and the keys are removed. Use a flathead screwdriver or a trim removal tool to gently pry around the edges of the cup holder to release it from the dashboard. If there are screws securing it, remove those with a Phillips screwdriver. Once loose, carefully pull the cup holder out from the dash.
The GE90-115B is the world records holder for the strongest engine.
It's located under the fuse box behind the air filter holder - loads of fun to replace....
To remove the cup holder from the dash of a Toyota Sienna, start by carefully prying off the surrounding trim using a plastic trim removal tool to avoid damage. Once the trim is removed, locate the screws or clips securing the cup holder in place and unscrew or unclip them. After that, gently pull the cup holder out from the dash. Always refer to the vehicle's manual for specific instructions pertaining to your model year.
Look under the dash behind the coin holder. Cheers
open the meter, buy a new bulb , put it in holder , refix
by the drivers side kick panel under coin holder labeled "dome"
2 peice of foam & use to sandwich multiple different size cables ? jacketed cable PUE/PVC MATERIAL .
86-93 its on the driver side foot kick panel. By the fuse holder.