0
is the battery dead? you might need a new starter that should be around 200 dollars.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
1993 Buick park avenue will not start?
my 1993 buick park avenue wont start after i changed the front motor support you can jump it from the sodinoid and it will crank whats wrong could it be the security system
Clear fault codes 2000 Buick park avenue?
The steering colums was changed on my 2000 buick park avenue and it still wont start. do I need to get the security light to go off first
1997 buick park avenue has good battery and alternator and new starter but wont start?
1.your ingnition could be bad, 2.your key could be bad
Your motor turn over but it wont start up on your 1991 buick park ave?
Do you have your parking brake on?
Will 22 inch rim and tires rud on a buick 1997 park avenue?
you'll need to install a suspension kit or the tires wont have clearance to turn in the wheel well...
Why wont fuel gauge on 97 Buick park ave work?
fuel gauge quit working on 1997 buick park ave. what is it?
Why wont my 1989 Buick Riviera start?
Check you battery
1992 Buick road master after you put a new battery it crank but wont start what is the problem?
1992 buick road master after you put a new battery it crank but wont start what is the problem
Whats up with my 1995 buick riviera the floor gear shift is in park but the indicator light says its in a different gear so it wont start?
if I'm thinking correctly its a bracket...
How do you open the door on a 1997 buick park avenue ultra if the inside and outside door handle wont open the door?
You have to pull the inside door panel off. Once removed, look for the door latch mechanism and pry it with a screwdriver. This will release the door.
Why wont your 1991 buick park ave start all the lights come on and all systems seem to be a go but you turn the key and nothing happens?
get your codes and go from there. It sounds like a crank shaft sensor.
1990 Buick park avenue key wont turn all the way to start the car when it just worked just fine a few hours ago?
suggestions, make sure key is installed the correct way, if its A double cut key try turning it over because the ignition is actually only got tumblers on one side, make sure the shifter is in park, If this does not work then I suggest replacing the ignition switch.
