faulty switch on gear box
Hi, there is a fuse for the turn signal and you can find it in the fuse box under the steering wheel exactly under the corner. it is very hard work to change it your nick may hurt you.
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
Remove the turn signal light bulb connector. Take hold of the light bulb, push in and turn at the same time, to remove the light bulb. Reverse the process to install the new light bulb.
how to turn off child-lock without remote daewoo DL-32C3
You have a faulty ground to one of the tail light bulbs and there is a reverse current flow back through the brake light circuit. It could be either front or rear turn signal light.
it goes under the brake pedal, it should twist out , it has two tabs on it , only about a half turn
Take hold of the turn signal light bald connector, push in and turn. The light bulb connector will come out with the light bulb. Remove the light bulb the same way you remove the connector. Reverse the process to install the new light bulb.
Some fault codes which cause the warning light to come on will clear themselves after a certain number of ignition sequences if the fault is no longer occurring. Give it a week or two and the light may clear. Failing that buy a code reader on eBay for about £20. You'll need a OBD II reader. You can clear the codes with it if you want. Of course you should fix the cause of the fault as well! May not be so simple . I bought such a reader and it does not give any info .Matiz seems to be a bit of a one off .tread carefully or you will be £20+ worse off and non the wiser. If you do or have cracked it please post type of scanner used.
Turn the wheels all the way to the right. Look between the back of the driver side wheel and the fender. You will see the reverse light switch just above the transaxle.
turn the round gray part behind the light, remove the wire and pull the bulb out, reverse to reinstall
do zero turn mowers mow in reverse
Remove the retaining ring to the light. The light will come out. Push the light in and turn at the same time. Reverse the process to install the new light.