answersLogoWhite

0


Best Answer

Not sure why blowing but if you can look in owners manual or chiltons to see what else is on the same circuit for example fuse #2 may have fuel pump and cigar lighter on the same circuit and if something metal falls into cigar lighter it will blow the fuse each time a new fuse is put in. Hope it helps. Also on my 1989 Chevy 2500 I had the same problem and I had a short in some wiring running along the driver side frame rail by the fuel filter.

User Avatar

Wiki User

19y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why would a 1990 Chevy 2500 blow the ignition ECM fuse?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the passlock sensor located on a 99' Chevy 2500?

Ignition lock cylinder


92 Chevy 2500 you have replaced the starter when you turn the key the starter wont engage?

This could be a bad ignition switch, ignition relay, or ignition fuse.


How do you replace the ignition switch on your 1993 Chevy K 2500?

Remove the retaining ring at the top of your 1993 Chevrolet K 2500 ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.


What is the correct spark plug gap on a 1990 Chevy 2500 pickup 5.7L?

Depending on the type of plug, the gap for a 1990 Chevy 2500 pickup is between .045 and .060. The plugs should come pre gapped.


How do you replace the ignition switch on a 93 2500 Chevy?

You switch the carborator with the ac and then rewire the inside to the dashboard


What is the mpg for 1990 Chevy Silverado 2500?

About 12 MPG. HWY. 10 in town


Where can you find a stereo wiring diagram for a 1990 Chevy Cheyenne 2500?

You can find a stereo wiring diagram for your 1990 Chevy Cheyenne 2500 at most Chevrolet dealerships. The stereo wiring diagram will be in Chevrolet service manuals at your local library.


Why is the steering wheel in your 1990 Chevy 2500 so loose?

If the steering wheel on a 1990 Chevy 2500 feels loose, one or multiple bolts may need tightening. Threadlocker might need to be applied to the bolts to prevent them from coming loose again.


Why does my 98 Chevy 2500 keep stalling then it won't start?

bad ignition switch. had the same problem until I replaced it.


How do you change a fly wheel on a 1990 Chevy silverado 2500?

The transmission must be removed to change the flywheel.


What transmission did the 94 Chevy 2500 come with?

That would be the 4L80E.


What transmission is in the 1992 Chevy Suburban 2500?

That would be the 4L80E