0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What would cause 1988 Mercedes Benz 190e to overheat?
I could be something as simple as a vacuum line off. I had overheating issues on my 1991 190E and found a vacuum check valve broken. Look near the passenger side of the engine.
What is the ac oil capacity on a 1991 Mercedes 190e 2.6?
The 1991 Mercedes Benz 2.6 liter engine oil capacity is 4.5 quarts. The engine oil pan will hold 4.0 quarts and the oil filter will hold one half quart.
Where are the seat motors on a 1991 Mercedes 190E?
The motors are underneath the seats
Does the 1991 Mercedes Benz 190e 2.6 have an aluminium head?
Yes it does.
Are the headlights of a 1991 Mercedes 190E match with a 1995 Mercedes 220?
No they will not.
How do you remove cylinder head from 1991 Mercedes Benz 190e 2.3?
how remove cylinder head
Why does Mercedes 190e heat up when idle but when driven engine cools and no longer blows warm air in winter?
I have a 1991 190e 4 cylinder with the same problem - in cold weather the engine does not warm up. I know that I have a head gasket leak due to oil in coolant. I changed the thermostat but no improvement. I suspect the head gasket leak somehow affects the working of the thermostat or circulation of the coolant.
What car company produces the 190e?
The car company that produced the 190E model is Mercedes-Benz. This model was produced by Mercedes-Benz from 1982 through 1988 and again from 1991 through 1993.
What would cause the blinkers to stop working for a 1991 Mercedes Benz 190E?
I have now had the problem fixed, simply a bad connection under the dash. All is now fine.
How do you reset radio code on 1991 190e Mercedes?
enter code 11122, that should work. I needed the radio code for my 1992 Mecedes 190E, after the battery had been disconnected, so I called the dealer, who gave me the 4 digit code over the phone, no charge. I called and the code they gave me was shorter for a 190e it is 1133
Is the oil pressure gauge on a 1991 Mercedes 190E supposed to be pegged at 3 instead of in the middle of the gauge at 1.5?
i have a 1993 190E - my oil pressure gauge always sits on 3. ==New Answer Haedline == The oil pressure gauge actually moves but is related to several factors Engine Temprature Oil viscosity Engine speed. When you start you car the engine temperature is low the gauge goes to 3, after a long drive/travel and if your temp gets to 80C then with an engine speed of 750-800 RPM you oil pressure gauge will read about 1.5. if you rev. the engine the pressure gauge goes up to 3
Why does my 1991 MB 190E 2.3 cut out and after standing for 20 minutes it starts again?
Problem is most likely your alternator or your fuel pumps.
