answersLogoWhite

0

one of two reasons 1 The disk is scratched or dirty 2 the laser is dirty or out of calibration I would check disk condition first and clean with a soft cloth, if that didnt work I would use some compressed air and blow off the laser and as a last resort as it could damage your system, use a soft cloth and lightly wipe the laser lens off. use little to no presure as it could damage the laser beyond repair.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

When you type in the SSN or EDI number in jpas and click on display you may see what message?

When you enter the SSN or EDI number in JPAS and click on display, you may see a message indicating whether the information is valid or not, along with details about the individual's security clearance status, if applicable. If the number is not found or invalid, you might receive an error message prompting you to check the input. Additionally, it may display information regarding any restrictions or issues related to the individual's clearance.


What was the main message in Thomas Paine's Common Sense booklet?

To urge for independence and to cut ties with England


What is a general message?

General information posters are common in businesses. A poster that contains general information is used as a way to display opening and closing times, or holidays where the building may be closed.


When you type in the SSN or EDI number and click on display you may see what message?

When you enter the SSN or EDI number and click on display, you may see a message indicating whether the information is valid or if there was an error in the input. Possible messages could include "Record found," "No record found," or "Invalid number." Additionally, there may be prompts for further action if the information is incomplete or requires correction.


How do you get unlimited texts for 5 pounds a month on orange?

u buy a card and send a text message with a number from a booklet


How do you activate auto headlight on a xsara Picasso?

Turn the ignition key midway (electric position) the press on the button at the end of the wiper stalk until you hear 2 beep and message display on the information display "Automatic light inactive"


How do I make Taurus Message Center dim.?

message center display light brighter after I disconnected the battery


Can your computer display a message every half hour?

Yes.


Why does my Instant Pot display the "burn" message?

Your Instant Pot may display the "burn" message if the food is burning or sticking to the bottom of the pot, causing it to overheat and trigger the burn sensor.


How do you turn off the automatic headlights on a citroen Picasso?

Turn the ignition key midway (electric position) the press on the button at the end of the wiper stalk until you hear 2 beep and message display on the information display "Automatic light inactive"


How do you display a message in C?

In C, the most common way to display a message is by using printf. The following code example will display Hello There! and start a new line.Code Example:#include int main(void) { printf("Hello There!\n"); return 0; }


What information is in an Ethernet header and trailer?

The Basic Header contains information about the source of the message. The Application Header contains information about the message type and the destination of the message. The contents of the trailer block include both user information (checksum, message authentication, proprietary authentication, and so on) and system information (delayed message, message reference, possible duplicate message, and so on).