0
What else can I help you with?
How do you check if you have spark at the spark plug wires?
you would take out the spark plugs still attached to the spark wires. place the metal of the plugs onto a grounded metal spot. make sure they are not touching in order to prevent damaging them or blowing fuses.
How do you Change spark plugs on a Maruti Alto?
To change the spark plugs on a Maruti Alto, first, make sure the car is turned off and parked safely. Find the spark plugs at the end of the rubber-like wires in the engine. Remove the wire from the spark plus, remove the old spark plugs, and put in the new ones, and replace the wires.
What could make my 95 Chevrolet Tahoe with 166000 miles run rougher and vibrate a lot when its idling after a tuneup including spark plug wires spark plugs cap rotor air filter and oil change?
Probably have the wires crossed. Check and make certain all wires are on the correct plug and/or are in the right position on the distributor cap. Make sure they fit snugly on the plugs. You could even have a bad wire that came out of the box new (it happens).
Wont start you changed spark plugs?
You need to check wires. Make sure that you connected plug wires in the correct order. Check that wires are sitting tightly on spark plugs. If it didn't work, remove spark plugs and check the gap for all of them. Install the spark plugs and try to start again. If it didn't work install old spark plugs and try again. If it didn't work check the fuse box under the hood. Hopefully it works.
How do you change spark plugs on a 2004 Ford Fusion 2?
to change the spark plugs there are 5 steps to this: step 1: remove spark plug wires. step 2: find the right size spark plug socket and rachet. step 3: losen spark plugs until they come out. step 4: install new spark plugs into cylinder, but make sure not to cross thread them it is very easy. step 5: replace spark plug wires on to new spark plugs. and youre done
How do you stop my 95 deville from misfiring?
Get a tune up. Replace cap and rotor, spark plugs, spark plug wires, and make sure the wires are in the correct firing order.
How do you change spark plugs in 2006 Toyota Tacoma?
When changing the spark plugs on a 2006 Toyota Tacoma make sure the vehicle is off. Use a spark plug socket and pull the spark plug wires. Remove the old spark plugs and properly space and install the new parts.
What makes a vehicle shake after changing the plugs and wires and it was not doing that before?
one of your wires is most likely loose so check that and if that isn't it make sure your spark plugs are tight
What cause your 92 Plymouth voyager to knock after you changed the spark plugs and wires?
Check to make sure the wires are all tight and you have them in the correct firing sequence. Also make sure you put the correct plugs in.
You replaced spark plugs and wires now your car does not start?
make sure your coil wire is pluged in
What make my 1996 Cadillac deville pop and jerk beside spark plugs and wires?
its your Oxygen censer
How do you change the spark plugs on a 2.2 1995 cavalier?
Pull the spark plug wires off each of the spark plugs. Blow out the wells where the spark plugs are with compressed air as dirt accumulates there. Use a spark plug socket with an extension to remove the plugs. Make sure to gap your new plugs to the proper spec which is in the owners manual. Install the new plugs, making sure when you thread them in with the socket that they do not crossthread! It can be costly to rethread these holes. Reinstall the plug wires in the correct sequence.
