Wire 2 dvc 4ohm subs to 2 channel Amp-sub400rms4ohm amp 350x24 ohm rms 700x22 ohm rms 1400x1 4 ohm peak power Best way to set up?

Answer 1

This question makes little sense. Could you say what model amp it is? With two 4 ohm subs, you can either do 1 ohm or 4 ohm. Now if you have a bridgeable two channel, I think you can do a 2 ohm load. For a 4 ohm load, two 4 ohm subs, connect both positives from one side of the subs to the positive out. Then the negative coils from the opposite side (other side of the sub) to the negative output. Then connect the remaining negative and positive together on each subs. Look here http://www.the12volt.com/caraudio/woofer_configurations.asp