pump motor+overload+magnetic contactor+breaker
Kindly need wiring diagram fo 5.5hp water surface pumping machine
The simplest phase diagrams are pressure-temperature diagrams of a single simple substance, such as water. The axes correspond to the pressure and temperature. The phase diagram shows, in pressure-temperature space, the lines of equilibrium or phase boundaries between the three phases of solid, liquid, and gas.
If the wiring diagram calls for it,yes.
In industrial wiring 'three phase' green or bare copper is the norm for a ground. In home wiring 220/110 single phase, bare copper is the ground
It sounds like you have a three phase motor that you are trying to put in where you have a single phase 120volt motor. You can purchase a three phase inverter, but the cost will exceed the cost of the new motor sized for the right wiring and voltage.
If the motor is 3-phase (it will say so on the nameplate), you don't need a diagram. just hook up all 3 wires in any order. If the motor runs the wrong direction, swap any two of the phases. This is true for all 3-phase motors. Its that simple! Warning: this obviously will only work if you have 480v, 3-phase power available. If you are trying to do this at home, it almost certainly won't work, because homes (in the US) typically have 240v 1-phase power. Trying to run a 3-phase motor directly on single phase power will destroy it. There are various ways to convert single phase power to three phase, but if you are having a hard time just hooking up the motor, they are beyond your ability at this time. Get a qualified electrician to help you! It could save your motor, and quite possibly your life!
a three phase cage rotor motor wiring diagram,but its pretty much wire by numbers and a two way,key switch for emergency light wiring diagram.
Single phase.
Three phase wiring is rarely used in homes in the United States. It becomes a fairly complicated process when most homes have a single phase wiring system.
The connection wiring diagram is usually on the inside of the motor's junction box cover. If the motor has three wires at the junction box then these wires are connected to the three incoming supply wires. If there is more than three wires, check the motor's nameplate to see if the motor is a dual voltage motor.
You should not need a wiring diagram. If the generator has a star point (wye) connection then the phase voltage to ground (star point) is 277 volts. 480/1.73 = 277.
Look on the inside of the motor's junction box. This is where the wiring diagram is located and it will tell you what connections to make.
This is the three component phase diagram for lime (CaO), ferrous oxide (FeO), sand (silica, SiO2).
you have to ceck all your wire that is mains
Well that is probably a very complicated circuit. You should just look for a Inverter with 220V single phase input and 415V three phase output. It should be that hard to find.
The wiring system in all probability will be a three phase system.
This point is call the "triple point" and this is where all three lines meet together on the phase diagram.
the triple point