0
Would it be ok to rplace the 25v 680 uf capacitor with a 25v 1000 uf on a xboard in a lcd tv?
Wiki User
∙ 8y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Does 001 farad of capacitor have polarity?
Only electrolytic capacitors (tantalum capacitors are a type of electrolytic capacitor) are polarized.0.001 farad = 1000 microfaradThis is a value that is too large for any practical capacitor except an electrolytic, so yes it will be polarized.
What rating of capacitor is used on single phase motor?
If a capacitor is directly connected across a motor then the capacitance of the capacitor will be calculated as under.Q = 0.9 * Sqrt (3) * V * I0.Here "V" = Supply voltage & I0 = No Load Current of Motor.AnswerThere is no need to connect capacitors across a three-phase motor.
What is the function of capacitor in full wave rectifier with smoothing capacitor circuit?
is a device that smoothen your half-wave rectification into a full-wave rectification after using a 4 diode and 1 resistor , after adding a capacitor , there will be a almost steady output , it charges the capacitor when is forward biased which is the first half wave , and discharge when is reverse biased to stablelize the wave into a almost same potential difference compare to a.c
How long time does it take to charge a 1000uF capacitor to 12 Volt through a 1000 Ohm resistor if your power source give 20 Volt?
It will take slightly less than one second (0.92 seconds) to charge a 1000uF capacitor to 12 volts through a 1000 ohm resistor if your power source is 20 volts.The time constant of a 1000uF capacitor in series with a 1000 Ohm resistor is 1 second. (1x10-3 Farads times 1x10+3 Ohms = 1 second) It takes 1 time constant to reach 63% of a step change, 2 time constants to reach 86% of step change, and so forth using the equation VT = V0 (1 - e (-T/RC)). See notes below12 is 60% of 20, so it will take about 0.92 seconds for the capacitor to reach 12 volts. In two seconds the capacitor will reach about 17 volts. In five seconds, five time constants, the capacitor will be considered to be fully charged, 99.3%, to 20 volts.Notes:VT is voltage after a given number of seconds. V0 is the total initial voltage, in this case, 20 volts. -T/RC is the negative number of time constants for the exponential equation e-TC, which a charging capacitor exhibits. (More specifically, e-TC is the proportion of voltage across the resistor, while 1 - e-TC is the proportion of voltage across the capacitor.)This equation is based on the fundamental equation of a capacitor...dv/dt = i/c... which states that the slope of the voltage is proportional to current and inversely proportional to capacitance. Plug this into an initial state differential equation, for the case of charging an initially discharged capacitor through a resistor, and you getVT = V0 (1 - e (-T/RC))(Derivation requires calculus, and that seems a little bit out of scope for this question.)
Is a miliohm 1000 ohms?
No, a miliohm is 0.001 ohms. A kiloohm is 1000 ohms.
A 1000 uF capacitor hold 9.2 coulombs of charge what is the voltage on the capacitor?
9200 volts my 1000 uF capacitor only holds 10 volts
What is the difference between a 1000 micro farad capacitor and a 1500 micro farad capacitor?
about 500 uF
Would a 12 volt battery need to use a capacitor to run a 1000 or 760 watt amp?
I have a 760 watt amp powering 2 10" subs and it works fine. my brother has a 1000 watt amp powering 2 12" subs and he got a capacitor. So it really depends on what amp your looking at. if the 760w you wont need one, if the 1000w i would be safe and buy a capacitor. for the 1000w amp you would only need a 1 or 2 farad capacitor.
What size capacitor you need for a 1000 watts amplifier?
It takes 1 farad for every 1000 watts so u need 2 farads.
Can a capacitor be gradually charged by lesser capacitors?
A: SURE capacitors in parallel will share the charge. But don't expect a .0001 mfd capacitor to charge a 1000 mfd capacitor. It just does not have the power stored to effectively charge the 1000 mfd. EXAMPLE 1litter of water cannot fill up a 5 litter container
What does a capacitance meter do?
A capacitor meter measures the value of a capacitor in pf (picofarads), nf (nanofarads), uf (microfarads) or even farads. There are a million uf in a farad, 1000 nf in a uf, and 1000 pf in a nf. A farad is a very large amount of capacity. The capacity tells you how much energy the capacitor can store from a voltage source.
Which capacitor is best for a 1400Watts amp?
It you mean a cap then it's 1 farad for every 1000 watts. So you would want a 1.5 farad cap. Or a 2 farad would work as well.
Does 001 farad of capacitor have polarity?
Only electrolytic capacitors (tantalum capacitors are a type of electrolytic capacitor) are polarized.0.001 farad = 1000 microfaradThis is a value that is too large for any practical capacitor except an electrolytic, so yes it will be polarized.
What does 35V and 1000uF on capacitor specify?
1000 microfarads is its rated capacitance, while 35 volts is its rated voltage.
Can you replace 820 microfarads 6.3v capacitor with 1000 microfarads 6.3v capacitors?
usually yes. what is it being used for?
What is the capacitive resistance of a 0.04 microfarad capacitor in ac circuit that has a frequency of 1000 hz?
The capacitive reactance is approximately 4 kΩ .
What would be 1000 rounded to the nearest ten?
1000
