When you change a pump,you should change the new hose that comes with it, and check that you have a good fit,good clamps, If you know all that is good.Try turnine the switch on until the pump quits about 5-10 seconds, Do that several times,after that, If you have done a good job, It should start
2010 chevy malibu intake position sensor
Just below the PS pump
behind the engine
The crank sensor on a 2003 Chevy Malibu is located on the bottom , right side of the engine. It is positioned near the oil filter and constantly monitors the rotation of the crankshaft.
my 2002 Chevy Malibu theft system is faulty if the car doesnt start whyen u first crank jit the theft light blinks and u have to wait 10 min while it flashes till it stops then turn the key of then start it what could be the problem.
The 1997 Chevrolet Malibu crank position sensor is located on the back of the crankshaft. The rear engine cover will need to be removed in order to view the sensor.
Its your fuel pump very common on those cars
Check the Malibu crank position sensor and coil pack. One of these is the most likely cause of the loss of fire.
Have you replaced the cam and/or crank sensor?
The 1997 Chevy Malibu crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
where is the crank shaft pistion sensor located on a 2002 Chevy Malibu, and how hard is it to replace
The crank sensor on a 2001 Malibu is located on the bottom of the engine near the crank shaft. It monitors the rotation and speed of the crank shaft.