#4 thhn copper or # 2 aluminum
bed
My memory says correct gauge for 100 amp service is 1 0 (that is, one ought) I could be wrong, check with your power company or building inspector.
Copper SE cable gauge 00 from the meter socket to the breaker panel for a 200A service. Then 8, 10, 12, and 14 gauge wire depending on the load.
how deep should water line be from meter to house in Versailles Kentucky
what should the volt meter guage read in my '93 Jeep Wrangler 13.5 to 14.2?
Because Pressure gauge measures the the differenceof pressure so it is called pressure gauge not meter.
Number 2 American Wire Gauge
The point of connection will be at the utility meter base, Whether the service is installed from a pole (overhead) or underground. In an overhead installation, the conductors may physically attach to the house at points other than the meter base, but they will always end up at the meter base.
1.676m,1.00m
Usually the power provider will conned the wires to the transformer. If your house if fed over head, your service will attached to an insulated attachment point on the house or service mast. Then they will pass through the meter, and then into the main breaker in your electrical panel. If your house is fed underground the service wire will be burred underground and enter the electrical meter from the bottom If you can elaborate a little more I can give you a more precise answer
1.09361
Meter gauge tracks are one meter or 39.4 inches apart. Standard gauge rails are 4 feet 8 and one half inches apart. Broad gauge is 5 feet between the rails. Most USA railroads use standard gauge although Broad gauge was common in the American South before the Civil War. It is still common in many parts of Russia.