If you restart the engine and putting it into gear causes it to stall replace the torque converter lockup solenoid as it has gone bad.
If pressing the gas pedal lightly with the right foot while braking with the left foot prevents the stalling (don't do this long term as it can be dangerous and can cause transmission problems and rapid brake wear) you very probably have a bad IAC (actuator) but it might also be a bad IAT sensor or low cooland level or bad ECT sensor or dirty throttle body or sticking EGR valve.
Nope.
The 1984 Cutlass is a model of car produced by the company Oldsmobile. The oxygen sensor is typically located near or on the engine block.
1984 brogham98
Oldsmobile was a brand of vehicles built by GM. They are no longer build. I own a 1984 Cutlass Supreme in beautiful condition.
With the lights on pull on the turn signal lever. High beams should come on. Pull again and they should go off.
were abs anit-lock brakes system
Gap it at .60
I got a 85 cutlass and its got tha same thing
be more specific, bleed, what kind, or crossreferences of other models..
no.Oldsmobile and Chevy don't mix
Was there a 1984 Oldsmobile Cutlass Calais? I see them listed at 1988-1991. Assuming that you mean "wiper blade" (blade and frame) which are replaced often rather than "wiper arm" (piece from the spindle at the hood to the wiper blade) which are rarely ever replaced, ALL 1988-1991 Oldsmobile Cutlass Calais' have 3/16" Side Lock wiper arm attachments. See Sources and Related Links below.
1 2 3 4 5 6 clockwise