the door striker needs adjusted along with possibly the latch mechanism.
Should be in the power distribution block under the hood My fuse box on my 2000 Monte Carlo is at the end of my dash on the drivers side..To acsess the door must be open..
pull hard
The label on the drivers door jamb should have the recommended pressure.
Yes
There is no such thing as a 2009 Monte Carlo
take the inside door panel off and the water paper, disconnect any rods from the handle and then there should be 2 bolts that hold the handle on, take the bolts out and the handle will come out.
No
Yes
There is no such thing as a 2008 Monte Carlo
no there isnt
well either your heater core is bad or your outer window door seal is leaking . i had the same problem on my Monte Carlo and i had to remove 1 of the studs that hold on the weather striping on the lower part of the door so it could drain .
Yes... Sort of anyway. The Monte Carlo uses a 4 door Chevelle frame even though the Monte Carlo is a 2 door car. The 4 door frame is longer than the 2 door Chevelle frame. and the wheelbase is 4 inches longer. So if you have a Monte Carlo, a 4 door Chevelle frame will work. If you have a 4 door Chevelle, a Monte Carlo frame will work. If you have a 2 door Chevelle, then you will need to use a frame from ANY 2 door GM A body except for the Monte Carlo.... The Tempest/Lemans/GTO, Cutlass, Skylark, and Chevelle all used the same frames and are completely interchangeable.