They are located under the air inlet grill directly in front of the windshield. You have to remove the wiper arms and antenna to remove the grill.
The 2002 Chevrolet trailblazer windshield wiper motor should be replaced, when the windshield wipers are skipping. The windshield wiper motor can be located in the engine compartment.
wiper motor on lincoln towncar 02
on the bottom of the wiper motor. its where the cables plug into
The wiper cowl is the area at the base of the windshield that houses the wiper motor.
about 200 quid
driver side under plastic cowl at base of windshield
Disconnect battery.
To replace the windshield motor on a 2002 Kia Optima, use a fused jumper wire to bypass the relay of the wiper motor. Then use the positive lead to touch the positive terminal on the relay. Remove all mounting bolts of the windshield motor and gently pull the motor out. Replace with new.?æ
There was a recall on the windshield wiper motors. Check with your locate dealer and they may replace it for FREE!!!!
The 2002 Jeep Liberty takes 19" replacement windshield wiper blades on both sides front.
Windshield Wiper Motor Removal & Installation Front 1. Turn the ignition switch to the ON position. Turn the ignition switch ON until the wiper blades are straight up, then turn the ignition switch OFF. 2. Disconnect the negative battery cable. 3. Remove the right-hand and left-hand windshield wiper arm and blade assemblies. 4. Remove the cowl top vent panels. 5. Detach the electrical hardness connector at the windshield wiper motor assembly. 6. Remove 3 wiper motor (module assembly) retaining bolts and remove the module assembly from the vehicle. 7. Remove the wiper linkage retaining bolt and remove the linkage from the wiper motor. 8. Remove 3 retaining nuts and remove the windshield wiper motor. To install; 9. Place the windshield wiper motor in position and install 3 retaining nuts. Tighten to 10-12 ft. lbs. (12-17 Nm). 10. Connect the wiper linkage to the windshield wiper motor and install the retaining bolt. Tighten the bolts to 14 ft. lbs. (20 Nm). 11. Place the wiper motor (module assembly) in position and install 3 retaining bolts. Tighten the bolts to 6 ft. lbs. (9Nm). 12. Install the electrical hardness connector to the windshield wiper motor. 13. Connect the negative battery cable. 14. Allow the windshield wiper motor to cycle several times while checking for proper wiper motor operation. 15. Turn the windshield wiper motor to the OFFposition to park the wiper motor in the park position. 16. Install the cowl top vent panels. 17. Install the wiper arm and blade assemblies. Install the retaining nuts and tighten to 22-29 ft. lbs. (30-40 Nm). 18. Connect the negative battery cable. 19. Check the windshield wiper motor for proper operation and the wiper arms for adjustment.
The 2002 Chevy Trailblazer takes 22" replacement windshield wiper blades on both sides front and a 16" rear wiper.