behind the headlight is a locking ring with a electrical connector going to it. the locking ring twists off. twist it counterclockwise about a 1/3 of a turn and it should just pull off. Disconnect the wire connector by gently pulling upward on the tab and pulling away from the front of the bulb. then take your new bulb, place the ring on it and place it into the headlight housing without touching the bulb if at all possible. twist the locking ring clockwise until it stops or 1/3 of a turn and reconnect the wire harness. there are some orientation grooves in the bulb and on the headlight housing to make sure the bulb is in the correct position. if these arent lined up you will not be able to twist on the locking ring. the electrical connector is also a shaped connector which will not allow you to install it improperly without extreme force to insert it into the connector.
To replace a headlight switch in a 1997 Chydler Town and Country, disconnect the negative battery cable and remove the screws around the switch. Pry the retaining ring that holds the switch in place and replace.?æ
Charge it, test it, replace it.
No,No,
100,000 miles
what are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi what are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi
A 1997 Sebring does not have a cabin filter.
A Chrysler Sebring does not have a reset switch.
Replace the blown fuse, or repair the broken wire.
Chrysler 41 TE
A Chrysler Sebring does not have a reset switch.
No.No.
5W20
OPen the trunk or hood, pull out the panel and replace the bulb... If that doesnt work, check your fuses