How do you set the time on a aurora touch alarm clock?

Answer 1

I had this same problem but i found the instructions.

You press and hold the alarm button (AL) while pressing the up and down keys to change the alarm time. Keep holding the alarm button and press the "SET" button to change from hours to minutes. Then use up/down keys to set minutes.

Hope that helped!!!

Answer 2

To set the time on the Aurora Touch alarm clock, you can follow these general steps. While the model you own may have some variations, these instructions should provide a useful basic guide.

1. **Alarm Turn On Clock**:

• Make sure your alarm clock is connected to a power source or has sufficient batteries.

2. **Enter Timing Mode**:

• Look for the button labeled "Set" or "Mode". Press and hold the button for a few seconds until the screen shows the time setting mode.

3.Set the Jam:

• After entering the time setting mode, use the "+" or "-" button to measure the jam. Some models may use a “Clock” button to set specific jams.

• If there is another button that must be pressed to move from the hour to minute setting, press that button.

4. **Set Minutes**:

• After setting the jam, use the "+" or "-" button again to measure the minutes.

• Make sure the time set is correct according to AM or PM if your alarm clock uses 12 hour format.

5. **Save Settings**:

• After setting the hours and minutes, press the "Set" or "Mode" button again to save the time setting. Typically, pressing this button will end setup mode and return the watch to normal display mode.

6. **Set Alarm**:

• To set the alarm time, repeat the steps above but in alarm setting mode. Usually, there is a separate button to enter the alarm setting mode.

If you encounter any difficulties or your alarm clock has additional features not covered in this guide, we recommend referring to the specific user manual for your Aurora Touch model. The manual usually provides a more detailed and specific process.