answersLogoWhite

0

An oar is a class 3 lever. This is because the oar, like all class 3 levers, is not used to reduce the force needed to move the load, but is used to increase the amount of travel of the load.

User Avatar

Wiki User

15y ago

What else can I help you with?

Continue Learning about Computer Science

How many ip addresses are there in a class A?

There are 2^24 host in class A but (2^24)-2 hosts are valid since the first and last address are reserved .


Where is the starter motor on an A class Mercedes?

With the vehicle on a lift/hoist you need to undo/lower and lever down the back of the sub frame. You can then just see it/reach it. It's a crap job, good luck.


What class of network is each IP addresses?

CLASS A - 1-126 (10.0.0.0) 1 n/w, 3 host CLASS B - 128-191 (172.16.0.0) 2 n/w, 2 host CLASS C - 192- 223 (192.168.0.0) 3 n/w, 1 host CLASS D - 224-239 CLASS E - 240- 254


What is the difference between class 4 and class 6 SDHC memory card?

The high capacity microSD, aka microSDHC, are those microSD cards with capacities in excess of 2 gigabytes that adhere to the SD Association's standard for high capacity cards. What does the Class Rating mean? What does that "C" with a 4, 6, 10 or 2 inside it signify?The class refers to the data transmission speed (DTS) of the card, its ability to accept and send information from the device in which it is installed. If you know how quickly a device can read and write to the card you can more closely match the card to it. There is no sense in putting a Class 6 card in a device that writes so slowly that a Class 2 card is sitting there twiddling its virtual thumbs waiting for bits.As a rule of thumb the class of a card is the sustained data transfer speed (DTS) in Megabytes per second (MBS)CLASS 2 = 2 Megabytes per SecondCLASS 4 = 4 Megabytes per SecondCLASS 6 = 6 Megabytes per SecondCLASS 10 = 10 Megabytes per SecondA good rule of thumb is to install the matching or next fastest class card in your device to get the maximum performance at the least cost. If you have a device that is capable of fully utilising a CLASS 6 card and you saddle up a CLASS 2 you will impair its functionality. In a camera that will slow down how quickly you can take the next photo. In a device that is capable of transferring 1.5MBS if you install a CLASS 6 card you are wasting your hard earned money. Prices for a CLASS 2 and a CLASS 6 device can be as much as 100% premium for the CLASS 6 over the CLASS 2 for the same amount of storage.Class ratings also apply to the full sized SD cards.CLASS 2 SDHC Card CLASS 2 iconCLASS 4 microSDHC CLASS 4 icon up close and personalCLASS 6 SD card CLASS 6 IconThe images are from Kingston products. The CLASS icons are not exclusive to any particular manufacturer but are used across the industry and are trademarks of the SD Association. As can be seen the symbol is a san-serif C with the numeral of the class rating inside.When shopping on eBay for SDHC or microSDHC know your class. If a seller has obscured the class icon or does not let you know from the description what class he or she is selling either ask or move on.


How many hosts can possible in a class A ip range?

class A ip has 16777216 host but valid hosts are only 16777214.(2^24-2)So answer is 16777214 hosts

Related Questions

What class are rowboat oars?

an oar is a 2 class lever


What class of lever does a oar of a boat fall in?

The oar of a boat falls under the class 1 lever, where the fulcrum is between the effort (force applied) and the load (boat).


What kinda of simple machine is a boat oar?

a second class lever


What class of lever is a oar?

An oar is a type of lever that falls under Class 1 lever. This is because the pivot point (fulcrum) is at one end, the input force is applied at the other end, and the output force (the resistance) is found between the two.


What kind of lever is an oar?

An oar is a type of Class 3 lever, where the effort (force applied) is between the fulcrum (pivot point) and the resistance (the water the oar pushes against). In this case, the oar handle is the effort, the oar blade acts as the resistance, and the boat acts as the fulcrum.


What type lever is a rowboat oar?

2


Why is an oar a second class lever Giving reasons?

The answer is that it is NOT. It is a first class lever. "Class 1: the fulcrum is located between the applied force and the load. Example: the crowbar" - Wikipedia In regular use, the fulcrum of the oar is attached to the top side or edge of the water craft, which is between the force being applied by the rower and the "load", being the resistance of the water itself. This makes the oar a classic example of a first class lever.


Is an oar a first class lever?

Yes, but its Mechanical advantage is usually less than 1


Why is an oar on a boat a second class lever?

An oar on a boat is considered a second-class lever because the fulcrum (pivot point) is at one end (the oarlock), the effort is applied at the other end by the rower's hands, and the load (the resistance to be overcome, in this case, the water) is in between.


What class lever is pliers?

The Class Lever for Pliers is a class 2 lever.


What class lever is a row boat?

A row boat is considered a second-class lever. In this type of lever, the load is located between the effort and the fulcrum. The oar acts as the effort, the load is the boat and the rower, and the pivot point is the fulcrum.


Is a bottle opener a class 1 lever a class 2 lever or a class 3 lever?

Class 1 lever