BC 560XLT 16-Channel Direct Entry Programmable Scanner
PROGRAMMING CHANNELS
1. Turn on your scanner by turning the volume clockwise.
2. The scanner might strart scanning. If so, press MANUAL to stop the
scanning.
3. Enter the channel number that you want to program and press MANUAL.
4. Enter a frequency including the decimal point. The decimal point shows
up on the display as a -- (dash).
5. Press Enter to store the frequency.
6. To confirm the proper entry, press REVIEW. The programmed frequency
appears on the display one digit at a time.
7. To program more channels repeat steps 3-4.
easy to program
Scanner codes
Try programing in 000.000, if that does not work then you can just lock the frequency out or program over it.
To program a Uniden Bearcat BC60XLT scanner, first, turn on the device and select the frequency band you want to program. Use the "Manual" button to enter the desired frequency, then press "Enter" to save it to the selected memory channel. You can also use the "Search" feature to find active frequencies within a range. For more advanced programming, consult the user manual for details on using the memory banks and scanning modes.
To program a Uniden Bearcat BC245XLT handheld scanner, first power on the device and press the "MANUAL" button to select a channel. Use the keypad to enter the desired frequency, then press "E" to save it. For trunked systems, press the "TRUNK" button, select the trunk type, and enter the control channel frequency. Finally, use the "SCANNER" button to start scanning the programmed frequencies.
Follow the link to download/print the manual for your scanner. It will walk you through the programming process. http://www.uniden.com/pdf/BC72XLTom.pdf
You don't. The good news, though, is that all Uniden/Bear at scanners in the 14X series are nearly identical in features and operation, so you can follow the link below to download/print the manual for the BC148XLT: http://www.radiopics.com/1.%20Manuals/Bearcat/Bearcat%20BC148XLT%20%28Manual%29.pdf Bill B
it takes a 8 digit number example 1550.0100 palestine Texas
To program your BC60XLT-1 Uniden Bearcat scanner in Washington State, first, locate the frequencies for local police, fire, and emergency services, which can often be found on websites like RadioReference. Turn on the scanner and press the "MAN" button to enter manual mode, then use the keypad to enter the desired frequency. You can also program channels by accessing the "PRG" mode, selecting an empty channel, and entering the frequency. Finally, ensure that you save your settings and scan for the programmed channels.
See the related link below for Jasper County, Texas.
INPUT: AC 120V 60Hz OUTPUT: DC 12V 200mA
To reset a Uniden Bearcat scanner, first turn off the device. Then, while holding down the 'Hold' and 'Function' buttons, turn the scanner back on. Continue to hold the buttons until the display shows "Initializing" or "Resetting." This process will restore the scanner to its factory settings, erasing any stored frequencies and settings.