Appliances have what is called a nameplate on them. Thisprovides model and serial number info., but also how much current, volts, and watts the appliance is rated for. You will need to read this in order to know how to size the overload protection. In America, the NEC requires two 20-Amp small appliance circuits in new or remodeled kitchens. The refridge circuit is generally on it's own 15-Amp circuit. The microwave (if built-in over the range) is also on it's own 15-Amp circuit. The dishwasher and disposal generally will share a 20-Amp circuit.
Yes provided the adaptor, or the plug that is plugged in, has a 13A fuse.
All UK-style 13-A plugs are fitted with a fuse for the purpose of overcurrent protection. The fuse rating must be appropriate for the load supplied by the plug, up to a maximum of 13 A.
No, you should not plug a device that requires 125 volts into a 220-volt outlet as it may cause damage to the device or create a safety hazard. It is important to always use the correct voltage outlet for your devices to prevent damage and ensure safety.
Answer for UK, Europe and countries running a 50 Hz supply service.The easiest way to check is to remove the plug from the wall socket, and open it. The rating will be written on the fuse and is given in Amps. Sometimes devices come with a molded plug top (no screws, can't be opened), however there will be a slot on the underside of the plug which allows you to take the fuse out.The Amp rating of a fuse in a plug is an electrical safety standard.When a fuse burns out (blows) it is usually due to an electrical fault in the device, which should be fixed before replacing the fuse.You should never replace a blown fuse with a fuse of a different Amp rating, either higher or lower.In the UK and Ireland, plug tops should always come with a fuse with a rating that suits the appliance it is attached to.Generally these ratings will be either3 amps - for small things like lamps5 amps - Also for small things.10amps - no example13amps for bigger things like the Vacuum cleaner.13 amps is the highest rating a 3 pin plug should have.As always, if in doubt, contact a registered electrician.
I know what would happen. The three amp fuse would blow. Any device that is plugged into a receptacle with out having sufficient resistance to limit the current flow will dead short the circuit and cause the breaker that feeds the circuit to trip. In this case the fuse being of a lower rating that the feed breaker the fuse will blow without tripping the receptacle's feed breaker.
A fuse doesn't 'power' an electrical plug. A fuse protects the load supplied by that plug.
A fuse is fitted to a plug as a safety feature.
The auxiliary plug fuse can be found in the fuse box. The location of the fuse can be found on the inside cover of the fuse box.
No, fuse box fuses are of the screw in type. Plug in fuses are of a cartridge style that plug into the fuse holder which supports the fuse on either end of the cartridge.
The fuse has blown. Find the fuse box, find the fuse, replace/reset, get on with life. *********is fuse box the plug hole with a switch on it? There isn't one in the room, and how do I know if I found the right one?
The fuse is a safety feature.
no theirs no fuse
There is no fuse in the unit itself. The fuse in the charger in in the plug.
where is the glow plug fuse on a1995 masda bongo
A 4-amp fuse.
in the fuse box =]
If the fuse won't fit then you have the wrong size fuse. They make several different sizes and amps.