The base of the antenna has a spot where you can get a wrench around it. Turn counterclockwise and it unscrews.
you have to remove all of the upper interior paneling; the headliner comes down and there is your antenna. loosen the one nut, disconnect the wire from the back of the radio and pull it out. reverse your steps for installation of the new antenna. it took me about 45 minutes.
located in back window with rear defog
The molding around your radio pops off, you may need to pry in the cornors. take out the 4 screws that hold in the radio, pull out radio disconnect the antenna, power, than plug back in the new one, replace molding.
The molding around your radio pops off, you may need to pry in the cornors. take out the 4 screws that hold in the radio, pull out radio disconnect the antenna, power, than plug back in the new one, replace molding.
You maybe able to order it from a Chevy dealer or find a junk yard in your area
how do you replace antenna on a 1997 hyundai accent
Remove the wiring harness from the and of your 1997 Chevy Lumina antenna. Remove the antenna retaining nuts. Reverse the process to install the new antenna.
i just tried to do it.the part is one piece no plug.the guy is buying the part from GM i replace it next week. i believe it is one piece from fender to the radio.it comes in behind the heater box somewhere.
Begin by removing the cable from the bottom of your 1997 Ford Taurus antenna. Remove the antenna retaining nuts. Reverse the process to install your new antenna.
Assuming it is functioning, turn the radio on.
you have to remove all of the upper interior paneling; the headliner comes down and there is your antenna. loosen the one nut, disconnect the wire from the back of the radio and pull it out. reverse your steps for installation of the new antenna. it took me about 45 minutes.
how do you replace a antenna motor for a 2000 Toyota landcruiser
located in back window with rear defog
is the orange wire always hot
The molding around your radio pops off, you may need to pry in the cornors. take out the 4 screws that hold in the radio, pull out radio disconnect the antenna, power, than plug back in the new one, replace molding.
You can remove the radio from your 1997 Geo Tracker by taking the radio retaining cover off. You also need to take out the radio retaining screws. The last step is to?æremove the wiring harness and the antenna cable from the back of the radio.
Its on the right side of the hood. It runs under the hood and through the firewall to the back of the radio